ot1200: add support for EHCI

U-Boot 2014.10-17457-g0b23780-dirty (Nov 10 2014 - 11:41:04)

CPU:   Freescale i.MX6D rev1.2 at 792 MHz
Reset cause: WDOG
Board: ot1200
I2C:   ready
DRAM:  1 GiB
MMC:   FSL_SDHC: 0, FSL_SDHC: 1
SF: Detected M25P16 with page size 256 Bytes, erase size 64 KiB, total 2 MiB
In:    serial
Out:   serial
Err:   serial
Net:   using phy at 0

FEC [PRIME]
Hit any key to stop autoboot: 0
=> usb start
(Re)start USB...

USB0:   Port not available.
USB1:   USB EHCI 1.00

scanning bus 1 for devices... 4 USB Device(s) found => usb tree
USB device tree:
1 Hub (480 Mb/s, 0mA)
| u-boot EHCI Host Controller
|

  +-2  Hub (480 Mb/s, 2mA)
    |
    +-3  Mass Storage (480 Mb/s, 80mA)
    |    USBest Technology USB Mass Storage Device 0000000000028B
    |
    +-4  Vendor specific (480 Mb/s, 2mA)

=>

---
 include/configs/ot1200.h | 7 +++++++
 1 file changed, 7 insertions(+)

index d7696bd..9512b1e 100644
@@ -83,6 +83,13 @@
 #define CONFIG_GENERIC_MMC
 #define CONFIG_BOUNCE_BUFFER
 
+/* USB Configs */
+#define CONFIG_CMD_USB
+#define CONFIG_USB_EHCI
+#define CONFIG_USB_EHCI_MX6
+#define CONFIG_MXC_USB_PORTSC   (PORT_PTS_UTMI | PORT_PTS_PTW)
+#define CONFIG_USB_MAX_CONTROLLER_COUNT 2
+
 #ifdef CONFIG_MX6Q
 #define CONFIG_CMD_SATA
 #endif

1.9.3

Applied to u-boot-imx, thanks !

Best regards,
Stefano Babic

=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================