exynos: dts: Correct USB vbus-gpio numbering for Snow
Subsystems (2)
PATCH 1/1 exynos: dts: Correct USB vbus-gpio numbering for Snow
The current vbus GPIOs on snow make very little sense, their number is far above the maximum. As a result, USB doesn't work on snow.
Correct the GPIO numbering so they match the current scheme for exynos5. Tested both EHCI and XHCI to correctly work after this change.
--- arch/arm/dts/exynos5250-snow.dts | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
arch/arm/dts/exynos5250-snow.dts +2 -2
@@ -131,11 +131,11 @@ }; ehci at 12110000 { - samsung,vbus-gpio = <&gpio 0x309 0>; /* X11 */ + samsung,vbus-gpio = <&gpio 0xb1 0>; /* X11 */ }; xhci at 12000000 { - samsung,vbus-gpio = <&gpio 0x317 0>; /* X27 */ + samsung,vbus-gpio = <&gpio 0xbf 0>; /* X27 */ }; tmu at 10060000 {
Signature · 1 line
2.1.1
PATCH 1/1 exynos: dts: Correct USB vbus-gpio numbering for Snow
Quoted 7 lines · Sjoerd Simons
The current vbus GPIOs on snow make very little sense, their number is far above the maximum. As a result, USB doesn't work on snow.
Correct the GPIO numbering so they match the current scheme for exynos5. Tested both EHCI and XHCI to correctly work after this change.
Signed-off-by Sjoerd Simons <[email protected]>
PATCH 1/1 exynos: dts: Correct USB vbus-gpio numbering for Snow
In reply to Sjoerd SimonsQuoted 20 lines · Sjoerd Simons
The current vbus GPIOs on snow make very little sense, their number is far above the maximum. As a result, USB doesn't work on snow.
Correct the GPIO numbering so they match the current scheme for exynos5. Tested both EHCI and XHCI to correctly work after this change.
Signed-off-by Sjoerd Simons <[email protected]>--- arch/arm/dts/exynos5250-snow.dts | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)arch/arm/dts/exynos5250-snow.dts +0
-0@@ -131,11 +131,11 @@ }; ehci at 12110000 {
arch/arm/dts/exynos5250-snow.dts line 141
Quoted 10 lines
arch/arm/dts/exynos5250-snow.dts +2
-2- samsung,vbus-gpio = <&gpio 0x309 0>; /* X11 */ + samsung,vbus-gpio = <&gpio 0xb1 0>; /* X11 */ }; xhci at 12000000 { - samsung,vbus-gpio = <&gpio 0x317 0>; /* X27 */ + samsung,vbus-gpio = <&gpio 0xbf 0>; /* X27 */ }; tmu at 10060000 {
applied to u-boot-samsung.
Thanks,
Minkyu Kang.