mixed ssd/disk szenario question: moving lv from ssd ->disk?
Hi list,
I have an vg over multiple disks (ssd and standard disks) and a big thinpool-volume inside. From thin thinpool i create a lot of snaps (>200), which are normally explizit placed on the ssd (i can select the pv-path on lvcreate).
Now, after a time some of these snaps i dont need on the fast device and want to mv them to a slow pv (standard disk) as a kind of backup.
Ist it possible to "move" a lv from the ssd to a disk, if both devices are part of my vg?
Tfh!
Oliver
I think 'lvconvert --replace /dev/<ssd> VG/LV /dev/<slow disk>' will do what you want.
Hi Matthew,
thank you for the hint! In the lvconvert-manpage they write:
"This option is only available to RAID segment types (e.g. raid1, raid5, etc)"
So I assume this will not work with thinpool-devices, but using raid with this trick is another good idea.
Tfh!
Oliver
Am 18.11.2014 um 17:55 schrieb matthew patton:
Quoted 8 lines
I think 'lvconvert --replace /dev/<ssd> VG/LV /dev/<slow disk>' will do what you want.
_______________________________________________
linux-lvm mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/linux-lvm
read the LVM HOW-TO at http://tldp.org/HOWTO/LVM-HOWTO/
Hi Matthew,
i have to correct my last email: This works also with thinpool-lvs! Better said: There was no error message executing this command. Will walk on this way for more reults. Maybe the lvconvert-manpage is outdated?
Tfh!
Oliver
Am 18.11.2014 um 17:55 schrieb matthew patton:
Quoted 8 lines
I think 'lvconvert --replace /dev/<ssd> VG/LV /dev/<slow disk>' will do what you want.
_______________________________________________
linux-lvm mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/linux-lvm
read the LVM HOW-TO at http://tldp.org/HOWTO/LVM-HOWTO/
Dne 23.11.2014 v 12:47 Oliver Rath napsal(a):
Quoted 8 lines
Hi Matthew,
i have to correct my last email: This works also with thinpool-lvs! Better said: There was no error message executing this command. Will walk on this way for more reults. Maybe the lvconvert-manpage is outdated?
Tfh!
Oliver
Hi
I'm somehow missing the point here.
Could you please show us 'lvs -a -o+seg_pe_ranges'
Normally when you make a thin volume snapshot, the snapshot is sharing your blocks within thin-pool. So no space is allocated on any SSD for this. (And you cannot specify which block will be used in a thin-pool)
If you would be using 'old-snapshot' which does allocate 'extra' space for COW block -then you would probably see horrible performance with 200 snapshots...
And finally - standard command for moving extents around in a VG is - 'pvmove'.
Regards
Zdenek