intel graphics hd 530 problem: screen splitted 2 parts horizontally
Hi
we have "HP ProOne 600 G2 21.5-in Touch AiO" PC, equipped with "Intel HD Graphics 530" graphics card
We are using debian stretch (testing) based linux distro named pardus. But we have observed the same condition under ubuntu 16.04 LTS.
our problem is: screen divided half horizontally.
Our screen is splitted into equal 2 parts horizontally from the middle.
her is the screenshot: http://bit.ly/2mRvf3s
if we use "nomodeset" kernel parameter at the grub startup, we get one screen but this time we are locked to 1024x768 screen resolution. xrandr only reports this resolution. and we could not add newmode.
I have included some diagnostics below.
Thanks for your help
---lspci -kvvn
00:02.0 0300: 8086:1912 (rev 06) (prog-if 00 [VGA controller])
Subsystem: 103c:805e
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B- DisINTx+
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0
Interrupt: pin A routed to IRQ 128
Region 0: Memory at d0000000 (64-bit, non-prefetchable) [size=16M] Region 2: Memory at c0000000 (64-bit, prefetchable) [size=256M] Region 4: I/O ports at 3000 [size=64]
[virtual] Expansion ROM at 000c0000 [disabled] [size=128K]
Capabilities: <access denied>
Kernel driver in use: i915
Kernel modules: i915
---modinfo i915
selcuk@pardus:/tmp$ modinfo i915 filename: /lib/modules/4.9.0-1-amd64/kernel/drivers/gpu/drm/i915/i915.ko license: GPL and additional rights description: Intel Graphics author: Intel Corporation author: Tungsten Graphics, Inc. firmware: i915/bxt_dmc_ver1_07.bin firmware: i915/skl_dmc_ver1_26.bin firmware: i915/kbl_dmc_ver1_01.bin firmware: i915/kbl_guc_ver9_14.bin firmware: i915/bxt_guc_ver8_7.bin firmware: i915/skl_guc_ver6_1.bin ... depends: drm_kms_helper,drm,video,button,i2c-algo-bit intree: Y vermagic: 4.9.0-1-amd64 SMP mod_unload modversions signat: PKCS#7 signer: sig_key: sig_hashalgo: md4 parm: modeset:Use kernel modesetting [KMS] (0=disable, 1=on, -1=force vga console preference [default]) (int) parm: panel_ignore_lid:Override lid status (0=autodetect, 1=autodetect disabled [default], -1=force lid closed, -2=force lid open) (int) parm: semaphores:Use semaphores for inter-ring sync (default: -1 (use per-chip defaults)) (int) parm: enable_rc6:Enable power-saving render C-state 6. Different stages can be selected via bitmask values (0 = disable; 1 = enable rc6; 2 = enable deep rc6; 4 = enable deepest rc6). For example, 3 would enable rc6 and deep rc6, and 7 would enable everything. default: -1 (use per-chip default) (int) parm: enable_dc:Enable power-saving display C-states. (-1=auto [default]; 0=disable; 1=up to DC5; 2=up to DC6) (int) parm: enable_fbc:Enable frame buffer compression for power savings (default: -1 (use per-chip default)) (int) parm: lvds_channel_mode:Specify LVDS channel mode (0=probe BIOS [default], 1=single-channel, 2=dual-channel) (int) parm: lvds_use_ssc:Use Spread Spectrum Clock with panels [LVDS/eDP] (default: auto from VBT) (int) parm: vbt_sdvo_panel_type:Override/Ignore selection of SDVO panel mode in the VBT (-2=ignore, -1=auto [default], index in VBT BIOS table) (int) parm: reset:Attempt GPU resets (default: true) (bool) parm: enable_hangcheck:Periodically check GPU activity for detecting hangs. WARNING: Disabling this can cause system wide hangs. (default: true) (bool) parm: enable_ppgtt:Override PPGTT usage. (-1=auto [default], 0=disabled, 1=aliasing, 2=full, 3=full with extended address space) (int) parm: enable_execlists:Override execlists usage. (-1=auto [default], 0=disabled, 1=enabled) (int) parm: enable_psr:Enable PSR (0=disabled, 1=enabled - link mode chosen per-platform, 2=force link-standby mode, 3=force link-off mode) Default: -1 (use per-chip default) (int) parm: preliminary_hw_support:Enable preliminary hardware support. (int) parm: disable_power_well:Disable display power wells when possible (-1=auto [default], 0=power wells always on, 1=power wells disabled when possible) (int) parm: enable_ips:Enable IPS (default: true) (int) parm: fastboot:Try to skip unnecessary mode sets at boot time (default: false) (bool) parm: prefault_disable:Disable page prefaulting for pread/pwrite/reloc (default:false). For developers only. (bool) parm: load_detect_test:Force-enable the VGA load detect code for testing (default:false). For developers only. (bool) parm: force_reset_modeset_test:Force a modeset during gpu reset for testing (default:false). For developers only. (bool) parm: invert_brightness:Invert backlight brightness (-1 force normal, 0 machine defaults, 1 force inversion), please report PCI device ID, subsystem vendor and subsystem device ID to [email protected], if your machine needs it. It will then be included in an upcoming module version. (int) parm: disable_display:Disable display (default: false) (bool) parm: enable_cmd_parser:Enable command parsing (1=enabled [default], 0=disabled) (int) parm: use_mmio_flip:use MMIO flips (-1=never, 0=driver discretion [default], 1=always) (int) parm: mmio_debug:Enable the MMIO debug code for the first N failures (default: off). This may negatively affect performance. (int) parm: verbose_state_checks:Enable verbose logs (ie. WARN_ON()) in case of unexpected hw state conditions. (bool) parm: nuclear_pageflip:Force atomic modeset functionality; asynchronous mode is not yet supported. (default: false). (bool) parm: edp_vswing:Ignore/Override vswing pre-emph table selection from VBT (0=use value from vbt [default], 1=low power swing(200mV),2=default swing(400mV)) (int) parm: enable_guc_loading:Enable GuC firmware loading (-1=auto, 0=never [default], 1=if available, 2=required) (int) parm: enable_guc_submission:Enable GuC submission (-1=auto, 0=never [default], 1=if available, 2=required) (int) parm: guc_log_level:GuC firmware logging level (-1:disabled (default), 0-3:enabled) (int) parm: enable_dp_mst:Enable multi-stream transport (MST) for new DisplayPort sinks. (default: true) (bool) parm: inject_load_failure:Force an error after a number of failure check points (0:disabled (default), N:force failure at the Nth failure check point) (uint) parm: enable_dpcd_backlight:Enable support for DPCD backlight control (default:false) (bool) parm: enable_gvt:Enable support for Intel GVT-g graphics virtualization host support(default:false) (bool)
---selcuk@pardus:/tmp$ inxi -F
System: Host: pardus Kernel: 4.9.0-1-amd64 x86_64 (64 bit) Console: tty 1 Distro: Pardus GNU/Linux Devel
Machine: Device: desktop System: HP product: HP ProOne 600 G2 21.5-in Touch AiO
Mobo: HP model: 805E v: KBC Version 05.22 UEFI [Legacy]: HP
v: N12 Ver. 02.14 date: 08/16/2016Graphics: Card: Intel HD Graphics 530
Display Server: X.org 1.19.1 drivers: modesetting (unloaded:
fbdev,vesa)
tty size: 205x24 Advanced Data: N/A out of X
---selcuk@pardus:~$ xrandr -q Screen 0: minimum 8 x 8, current 1920 x 1080, maximum 32767 x 32767 eDP1 connected primary 1920x1080+0+0 (normal left inverted right x axis y axis) 293mm x 165mm 1920x1080 60.05*+ 59.93 1680x1050 59.95 59.88 1600x1024 60.17 1400x1050 59.98 1600x900 60.00 1280x1024 60.02 1440x900 59.89 1280x960 60.00 1368x768 60.00 1360x768 59.80 59.96 1152x864 60.00 1280x720 60.00 1024x768 60.00 1024x576 60.00 960x540 60.00 800x600 60.32 56.25 864x486 60.00 640x480 59.94 720x405 60.00 640x360 60.00 HDMI1 disconnected (normal left inverted right x axis y axis) VIRTUAL1 disconnected (normal left inverted right x axis y axis)
_______________________________________________
Intel-gfx mailing list
[email protected]
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
Quoted 10 lines · M. selcuk karaca
we have "HP ProOne 600 G2 21.5-in Touch AiO" PC, equipped with "Intel HD Graphics 530" graphics card
We are using debian stretch (testing) based linux distro named pardus. But we have observed the same condition under ubuntu 16.04 LTS.
our problem is: screen divided half horizontally.
Our screen is splitted into equal 2 parts horizontally from the middle.
Install and boot your OS is UEFI mode.
See https://bugs.freedesktop.org/show_bug.cgi?id=97822
BR,
Jani.
Signature · 5 lines
Jani Nikula, Intel Open Source Technology Center _______________________________________________ Intel-gfx mailing list [email protected] https://lists.freedesktop.org/mailman/listinfo/intel-gfx
Hi Jani
you are right, your weird(!) recommendation has worked!
Thanks for your help..
Quoted 11 lines · Jani Nikula
Quoted 10 lines · M. selcuk karaca
we have "HP ProOne 600 G2 21.5-in Touch AiO" PC, equipped with "Intel HD Graphics 530" graphics card
We are using debian stretch (testing) based linux distro named pardus. But we have observed the same condition under ubuntu 16.04 LTS.
our problem is: screen divided half horizontally.
Our screen is splitted into equal 2 parts horizontally from the middle.
Quoted 9 lines
Install and boot your OS is UEFI mode.
See https://bugs.freedesktop.org/show_bug.cgi?id=97822
BR,
Jani.
_______________________________________________
Intel-gfx mailing list
[email protected]
https://lists.freedesktop.org/mailman/listinfo/intel-gfx