Skip to contentSkip to conversation

cobalt: set Kconfig default to n

PATCH In review Hans Verkuil 2 participants 2 messages Jun 19, 2015

Subsystems (2)
Media (V4L/DVB) Cobalt media driver
lore
Share & tools
lore

Hans Verkuil

author
#0 lore raw

PATCH 1/1 cobalt: set Kconfig default to n

Since this board is a Cisco-internal board there is no point in having it compiled by default. So set the Kconfig default to n.

Signed-off-by Hans Verkuil <[email protected]>
drivers/media/pci/cobalt/Kconfig +1 -0
index 3be1b2c..4d0777a 100644
@@ -7,6 +7,7 @@ config VIDEO_COBALT
 	select VIDEO_ADV7511
 	select VIDEO_ADV7842
 	select VIDEOBUF2_DMA_SG
+	default n
 	---help---
 	  This is a video4linux driver for the Cisco PCIe Cobalt card.
#1 lore raw

Em Fri, 19 Jun 2015 08:31:05 +0200
Hans Verkuil <[email protected]> escreveu:

Quoted 2 lines

Since this board is a Cisco-internal board there is no point in having it compiled by default. So set the Kconfig default to n.

This should not change anything. The default for all options that aren't specified are already 'n'.

Quoted 19 lines
Signed-off-by Hans Verkuil <[email protected]>
drivers/media/pci/cobalt/Kconfig +1 -1
index 3be1b2c..4d0777a 100644
@@ -7,6 +7,7 @@ config VIDEO_COBALT
 	select VIDEO_ADV7511
 	select VIDEO_ADV7842
 	select VIDEOBUF2_DMA_SG
+	default n
 	---help---
 	  This is a video4linux driver for the Cisco PCIe Cobalt card.
 
--

To unsubscribe from this list: send the line "unsubscribe linux-media" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html