Skip to contentSkip to conversation

A problem about OX_ID reused by FCoE driver

DISCUSSION Rui Xiang 1 participant 1 message Jul 24, 2015

lore
Share & tools
lore

Rui Xiang

author
#0 lore raw

From: Wu Yanjiang <[email protected]>

Hi all,

On a system that was running 3.0.13-0.27-default, a problem that the OX_ID is reused by FCoE driver occurred. Which can be confirmed is that the problem is occurred at initiator side, but the reason how does it happen is unknown.

By the trace captured by JDSU protocol analyzer, the initiator initiated a read command about 10 seconds after the virtual link resumed . But about 10ms later, the initiator send ABTS to abort the read command. Then the OX_ID was reused for a new command immediately without abort response from target side and RRQ process.

Test environment :
Initiator OS: SLES 11 SP2 (3.0.13-0.27-default)
Initiator CNA: INTEL X520-SR2

Test step:
1.INTEL X520-SR2 connect to intel 82599 card in target directly 2.Initiator initiates write and read command to target by FCoE VN2VN protect 3.Disconnect the physical link then reconnect it

Any advice is welcome.

Thanks.