sunxi_nand_spl: Be smarter about where to look for backup u-boot.bin
PATCH 1/1 sunxi_nand_spl: Be smarter about where to look for backup u-boot.bin
We know when u-boot is written to its own partition, in this case the layout always is:
eb 0 spl
eb 1 spl-backup
eb 2 u-boot
eb 3 u-boot-backup
eb: erase-block
So if we cannot load u-boot from its primary offset we know exactly where to look for it.
--- drivers/mtd/nand/sunxi_nand_spl.c | 25 +++++++++++++++++++------ 1 file changed, 19 insertions(+), 6 deletions(-)
drivers/mtd/nand/sunxi_nand_spl.c +19 -6
@@ -355,18 +355,31 @@ static int nand_read_buffer(uint32_t offs, unsigned int size, void *dest,int nand_spl_load_image (uint32_t offs,unsigned int size,void *dest) { +#if CONFIG_SYS_NAND_U_BOOT_OFFS ==CONFIG_SPL_PAD_TO +/* +* u-boot-dtb.bin appended to SPL, use syndrome (like the BROM does) +* and try different erase block sizes to find the backup. +*/ const uint32_t boot_offsets[] = {0 *1024 *1024 +CONFIG_SYS_NAND_U_BOOT_OFFS ,1 *1024 *1024 +CONFIG_SYS_NAND_U_BOOT_OFFS ,2 *1024 *1024 +CONFIG_SYS_NAND_U_BOOT_OFFS ,4 *1024 *1024 +CONFIG_SYS_NAND_U_BOOT_OFFS , }; -int i, syndrome; - -if (CONFIG_SYS_NAND_U_BOOT_OFFS ==CONFIG_SPL_PAD_TO ) - syndrome =1 ;/* u-boot-dtb.bin appended to SPL */ -else - syndrome =0 ;/* u-boot-dtb.bin on its own partition */ +const int syndrome =1 ; +#else +/* +* u-boot-dtb.bin on its own partition, do not use syndrome, u-boot +* partition sits after 2 eraseblocks (spl, spl-backup), look for +* backup u-boot 1 erase block further. +*/ +const uint32_t boot_offsets[] = { +CONFIG_SYS_NAND_U_BOOT_OFFS , +CONFIG_SYS_NAND_U_BOOT_OFFS +CONFIG_SYS_NAND_U_BOOT_OFFS /2 , + }; +const int syndrome =0 ; +#endif +int i;if (offs ==CONFIG_SYS_NAND_U_BOOT_OFFS ) {for (i =0 ; i <ARRAY_SIZE (boot_offsets); i++) {
Signature · 1 line
2.4.3
PATCH 1/1 sunxi_nand_spl: Be smarter about where to look for backup u-boot.bin
Quoted 9 lines · Hans de Goede
We know when u-boot is written to its own partition, in this case the layout always is:
eb 0 spl
eb 1 spl-backup
eb 2 u-boot
eb 3 u-boot-backupeb: erase-block
These are all the same size on this particular chip/all known sunxi SoCs, right?
Quoted 4 lines
So if we cannot load u-boot from its primary offset we know exactly where to look for it.
(quoted diff) +2
-0+#else +> > /*
Review
Quoted 10 lines
(quoted diff) +10
-0+> > * u-boot-dtb.bin on its own partition, do not use syndrome, u-boot +> > * partition sits after 2 eraseblocks (spl, spl-backup), look for +> > * backup u-boot 1 erase block further. +> > */ +> > const uint32_t boot_offsets[] = { +> > > CONFIG_SYS_NAND_U_BOOT_OFFS, +> > > CONFIG_SYS_NAND_U_BOOT_OFFS + CONFIG_SYS_NAND_U_BOOT_OFFS / 2, +> > }; +> > const int syndrome = 0; +#endif
The relationship between half of SYS_NAND_U_BOOT_OFFS and an erase block here is a bit non-obvious in this context (the offset is 2 blocks so one block is half that).
Is there no suitable #define for the eb size which could be used here (and ideally in the definition of U_BOOT_OFFS too)? Could we add one?
Ian.
PATCH 1/1 sunxi_nand_spl: Be smarter about where to look for backup u-boot.bin
Hi,
Quoted 9 lines · Ian Campbell
Quoted 8 lines · Hans de Goede
We know when u-boot is written to its own partition, in this case the layout always is:
eb 0 spl
eb 1 spl-backup
eb 2 u-boot
eb 3 u-boot-backup
Quoted 4 lines
Quoted 1 line
eb: erase-block
These are all the same size on this particular chip/all known sunxi SoCs, right?
Nope, erase-block sizes is a property of the nand flash used, not of the SoC, so this can vary per board (and on some boards like the mk802 of which many production runs where done chances are it may vary between production runs...).
Quoted 19 lines
Quoted 4 lines
So if we cannot load u-boot from its primary offset we know exactly where to look for it.
(quoted diff) +2
-0+#else +> > /*Review
Quoted 10 lines
(quoted diff) +10
-0+> > * u-boot-dtb.bin on its own partition, do not use syndrome, u-boot +> > * partition sits after 2 eraseblocks (spl, spl-backup), look for +> > * backup u-boot 1 erase block further. +> > */ +> > const uint32_t boot_offsets[] = { +> > > CONFIG_SYS_NAND_U_BOOT_OFFS, +> > > CONFIG_SYS_NAND_U_BOOT_OFFS + CONFIG_SYS_NAND_U_BOOT_OFFS / 2, +> > }; +> > const int syndrome = 0; +#endifThe relationship between half of
SYS_NAND_U_BOOT_OFFSand an erase block here is a bit non-obvious in this context (the offset is 2 blocks so one block is half that).
Quoted 2 lines
Is there no suitable #define for the eb size which could be used here (and ideally in the definition of
U_BOOT_OFFStoo)? Could we add one?
This is all still developing a bit some testing has shown that it is possible for u-boot.bin to suffer from non correctable ecc errors while it sits in a non bad erase block (looks like the erase block should actually be marked bad, but isn't). In cases like this it may help to write multiple copies of u-boot at 1MiB offsets (since u-boot will fit in 1 MiB) so maybe I need to revise this patch to use 1MiB offsets instead.
So for now we should probably just let this patch sit in my wip branch for a bit until we've a better handle on this.
Regards,
Hans
Quoted 3 lines
Ian.
PATCH 1/1 sunxi_nand_spl: Be smarter about where to look for backup u-boot.bin
Quoted 15 lines · Hans de Goede
Hi,
Quoted 2 lines · Ian Campbell
Quoted 1 line · Hans de Goede
We know when u-boot is written to its own partition, in this case
the
Quoted 9 lines
Quoted 8 lines
layout always is:
eb 0 spl
eb 1 spl-backup
eb 2 u-boot
eb 3 u-boot-backupeb: erase-block
Quoted 7 lines
Quoted 2 lines
These are all the same size on this particular chip/all known sunxi SoCs, right?
Nope, erase-block sizes is a property of the nand flash used, not of the SoC, so this can vary per board (and on some boards like the mk802 of which many production runs where done chances are it may vary between production runs...).
This is what I started out thinking but somehow convinced myself the NAND was on the SoC itself... Partly because the division used in the code below assumes some amount of uniformity (or at least some relationship between the offset of eb2 and its size).
Quoted 22 lines
Quoted 19 lines
Quoted 4 lines
So if we cannot load u-boot from its primary offset we know exactly where to look for it.
(quoted diff) +2
-0+#else +> > > > /*Review
Quoted 10 lines
(quoted diff) +10
-0+> > > > * u-boot-dtb.bin on its own partition, do not use syndrome, u-boot +> > > > * partition sits after 2 eraseblocks (spl, spl-backup), look for +> > > > * backup u-boot 1 erase block further. +> > > > */ +> > > > const uint32_t boot_offsets[] = { +> > > > > > > CONFIG_SYS_NAND_U_BOOT_OFFS, +> > > > > > > CONFIG_SYS_NAND_U_BOOT_OFFS + CONFIG_SYS_NAND_U_BOOT_OFFS / 2, +> > > > }; +> > > > const int syndrome = 0; +#endifThe relationship between half of
SYS_NAND_U_BOOT_OFFSand an erase block here is a bit non-obvious in this context (the offset is 2 blocks so one block is half that).Quoted 2 lines
Is there no suitable #define for the eb size which could be used here (and ideally in the definition of
U_BOOT_OFFStoo)? Could we add one?
Quoted 6 lines
This is all still developing a bit some testing has shown that it is possible for u-boot.bin to suffer from non correctable ecc errors while it sits in a non bad erase block (looks like the erase block should actually be marked bad, but isn't). In cases like this it may help to write multiple copies of u-boot at 1MiB offsets (since u-boot will fit in 1 MiB) so maybe I need to revise this patch to use 1MiB offsets instead.
Sure.
Quoted 2 lines
So for now we should probably just let this patch sit in my wip branch for a bit until we've a better handle on this.
OK.
Quoted 15 lines
Regards,
Hans
Quoted 3 lines
Ian.