pcap->eth low TX performance
Hello,
Did anyone try to work with pcap PMD recently? We're testing our app with this setup:
PCAP --- rte_eth_rx_burst--> APP-> rte_eth_tx_burst -> ethdev
I'm experiencing very low TX performance leading to massive mbuf drop while trying to send those packets over the Ethernet device. I tried running ordinary l2fwd and got the same issue with over 80-90% of packets drop. When I substitute PCAP with another ordinary Ethernet device, everything works fine. Can anyone share an idea?
Signature · 5 lines
Sincerely, Yerden Zhumabekov State Technical Service Astana, KZ
Are you reading from the pcap faster than the device can transmit? Does the app hold off reading from the pcap when the ethdev is pushing back, or does it just tail drop?
Quoted 21 lines · Yerden Zhumabekov
Hello,
Did anyone try to work with pcap PMD recently? We're testing our app with this setup:
PCAP --- rte_eth_rx_burst--> APP->
rte_eth_tx_burst-> ethdevI'm experiencing very low TX performance leading to massive mbuf drop while trying to send those packets over the Ethernet device. I tried running ordinary l2fwd and got the same issue with over 80-90% of packets drop. When I substitute PCAP with another ordinary Ethernet device, everything works fine. Can anyone share an idea?
--
Sincerely,Yerden Zhumabekov
State Technical Service
Astana, KZ
tx burst sends, say, 10-15% percent of a supplied array. The tail is being ignored so I have to drop it to avoid overflow. Ethernet device is 82599.
In my app, I transmit all traffic through a ring then feed it to eth. That leads to overflow as well.
04.09.2015 20:03, Kyle Larose пишет:
Quoted 28 lines
Are you reading from the pcap faster than the device can transmit? Does the app hold off reading from the pcap when the ethdev is pushing back, or does it just tail drop?
On Fri, Sep 4, 2015 at 12:14 AM, Yerden Zhumabekov <[email protected] <mailto:[email protected]>> wrote:
Hello,
Did anyone try to work with pcap PMD recently? We're testing our app with this setup:
PCAP --- rte_eth_rx_burst--> APP->
rte_eth_tx_burst-> ethdevI'm experiencing very low TX performance leading to massive mbuf drop while trying to send those packets over the Ethernet device. I tried running ordinary l2fwd and got the same issue with over 80-90% of packets drop. When I substitute PCAP with another ordinary Ethernet device, everything works fine. Can anyone share an idea?
--
Sincerely,Yerden Zhumabekov
State Technical Service
Astana, KZ
Signature · 5 lines
Sincerely, Yerden Zhumabekov State Technical Service Astana, KZ