mtd: nand: mxs check maximum ecc that platfrom supports
Subsystems (3)
PATCH v3 1/1 mtd: nand: mxs check maximum ecc that platfrom supports
Check maximum ecc strength for each platfrom to avoid the calculated ecc exceed the limitation.
---
Original V2 mail thread:
http://lists.denx.de/pipermail/u-boot/2015-August/225362.html
Because is_cpu_type was not merged to uboot upstream at that time, this patch can not be compiled successfully. Since now is_cpu_type is already in uboot upstream master branch, this patch can be applied and built without failure.
Changes v3:
Add Scott's Acked by
Add Tim's Tested by
Changes v2:
Add Marek's reviewed by.
drivers/mtd/nand/mxs_nand.c | 9 ++++++++- 1 file changed, 8 insertions(+), 1 deletion(-)
drivers/mtd/nand/mxs_nand.c +8 -1
@@ -149,6 +149,13 @@ static inline uint32_t mxs_nand_get_ecc_strength(uint32_t page_data_size, uint32_t page_oob_size) {int ecc_strength; +int max_ecc_strength_supported; + +/* Refer to Chapter 17 for i.MX6DQ, Chapter 18 for i.MX6SX */ +if (is_cpu_type (MXC_CPU_MX6SX )) + max_ecc_strength_supported =62 ; +else + max_ecc_strength_supported =40 ;/* * Determine the ECC layout with the formula:
@@ -162,7 +169,7 @@ static inline uint32_t mxs_nand_get_ecc_strength(uint32_t page_data_size, / (galois_field *mxs_nand_ecc_chunk_cnt (page_data_size)); -return round_down (ecc_strength,2 ); +return min (round_down (ecc_strength,2 ), max_ecc_strength_supported); } static inline uint32_t mxs_nand_get_mark_offset(uint32_t page_data_size,
Signature · 1 line
1.8.4
PATCH v3 1/1 mtd: nand: mxs check maximum ecc that platfrom supports
Quoted 11 lines · Peng Fan
Check maximum ecc strength for each platfrom to avoid the calculated ecc exceed the limitation.
Signed-off-by Peng Fan <[email protected]>Signed-off-by Han Xu <[email protected]>Tested-by Tim Harvey <[email protected]>Reviewed-by Marek Vasut <[email protected]>Acked-by Scott Wood <[email protected]>Cc Stefano Babic <[email protected]>---
Applied to u-boot-imx, thanks !
Best regards,
Stefano Babic
Signature · 5 lines
===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de =====================================================================