Skip to contentSkip to conversation

Setting 3x3 NIC to 2x2

DISCUSSION Ben Greear 1 participant 1 message Nov 10, 2015 Qualcomm Atheros ATH10K wireless driver

lore
Share & tools
lore

Ben Greear

author
#0 lore raw

Hello!

For this case: 2 PCs, one 3x3 peregrine ath10k NIC in each. Once acting as AP, the other as a station. Testing UDP upload performance.

Someone reported a problem where they thought they had a 2x2 ath10k NIC but in reality it was 3x3. They had only the first two antenna connected.

Using stock Fedora 21 kernel and firmware-4.bin, performance was horrible..around 8-10Mbps UDP throughput at best. This was on 2.4 band, so VHT is disabled.

I think the first issue is that performance is so bad if you are missing a single antenna. (In my lab, a similar setup with 3 antenna connected was giving 120+Mbps throughput).

The second problem I saw only on non-stock firmware & driver, so of course problem could be related to that:

If I start up system in 3x3 mode, and then try to change to 2x2 by setting the tx-antenna mask with iw, then it *appears* that everything is passed down to the firmware properly, but performance is horrible (5-10Mbps). Forcing rate-ctrl to use a higher fixed speed makes things worse, so it's not just rate-ctrl messing up.

Restarting all network devices on that radio, which causes a soft NIC reboot, does not fix the problem. (I reset both AP and STA machines radios multiple times)

But, if I do a full reboot, then the system comes up happy and will negotiate up to 300Mbps nominal rate (ie, full 2x2 capabilities).

I suspect there may be bugs in setting up registers down in the firmware, but I have not taken a close look at it at.

As always, I'm curious if others have seen similar problems (or, tried this and NOT seen such problems.)

Thanks,
Ben

Signature · 8 lines
Ben Greear <[email protected]>
Candela Technologies Inc  http://www.candelatech.com


_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k