Skip to contentSkip to conversation

mtd: brcmnand: Add brcm,bcm6368-nand device tree binding

PATCH New Simon Arlott 1 participant 3 messages Dec 3, 2015

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

PATCH 1/3 mtd: brcmnand: Add brcm,bcm6368-nand device tree binding

Add device tree binding for NAND on the BCM6368.

The BCM6368 has a NAND interrupt register with combined status and enable registers. It also requires a clock, so add an optional clock to the common brcmnand binding.

---
 .../devicetree/bindings/mtd/brcm,brcmnand.txt      | 32 ++++++++++++++++++++++
 1 file changed, 32 insertions(+)
Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt +32 -0
index 4ff7128..16d7835 100644
@@ -45,6 +45,8 @@ Required properties:
 - #size-cells      : <0>
 
 Optional properties:
+- clock                     : reference to the clock for the NAND controller
+- clock-names               : "nand" (required for the above clock)
 - brcm,nand-has-wp          : Some versions of this IP include a write-protect
                               (WP) control bit. It is always available on >=
                               v7.0. Use this property to describe the rare
@@ -72,6 +74,12 @@ we define additional 'compatible' properties and associated register resources w
        and enable registers
      - reg-names: (required) "nand-int-base"
 
+   * "brcm,nand-bcm6368"
+     - compatible: should contain "brcm,nand-bcm<soc>", "brcm,nand-bcm6368"
+     - reg: (required) the 'NAND_INTR_BASE' register range, with combined status
+       and enable registers, and boot address registers
+     - reg-names: (required) "nand-intr-base"
+
    * "brcm,nand-iproc"
      - reg: (required) the "IDM" register range, for interrupt enable and APB
        bus access endianness configuration, and the "EXT" register range,
@@ -148,3 +156,27 @@ nand@f0442800 {
 		};
 	};
 };
+
+nand@10000200 {
+	compatible = "brcm,nand-bcm63168", "brcm,nand-bcm6368",
+		"brcm,brcmnand-v4.0", "brcm,brcmnand";
+	reg = <0x10000200 0x180>,
+	      <0x10000600 0x200>,
+	      <0x100000b0 0x10>;
+	reg-names = "nand", "nand-cache", "nand-intr-base";
+	interrupt-parent = <&periph_intc>;
+	interrupts = <50>;
+	clocks = <&periph_clk 20>;
+	clock-names = "nand";
+
+	#address-cells = <1>;
+	#size-cells = <0>;
+
+	nand0: nandcs@0 {
+		compatible = "brcm,nandcs";
+		reg = <0>;
+		nand-on-flash-bbt;
+		nand-ecc-strength = <1>;
+		nand-ecc-step-size = <512>;
+	};
+};
Signature · 4 lines
2.1.4

-- 
Simon Arlott
#1 lore raw

PATCH 2/3 mtd: brcmnand: Request and enable the clock if present

Attempt to enable a clock named "nand" as some SoCs have a clock for the controller that needs to be enabled.

---
Removed ctrl->clk not NULL check.

 drivers/mtd/nand/brcmnand/brcmnand.c | 64 ++++++++++++++++++++++++++++--------
 1 file changed, 50 insertions(+), 14 deletions(-)
drivers/mtd/nand/brcmnand/brcmnand.c +50 -14
index 35d78f7..cf0374e 100644
@@ -11,6 +11,7 @@
  * GNU General Public License for more details.
  */
 
+#include <linux/clk.h>
 #include <linux/version.h>
 #include <linux/module.h>
 #include <linux/init.h>
@@ -122,6 +123,9 @@ struct brcmnand_controller {
 	/* Some SoCs provide custom interrupt status register(s) */
 	struct brcmnand_soc	*soc;
 
+	/* Some SoCs have a gateable clock for the controller */
+	struct clk		*clk;
+
 	int			cmd_pending;
 	bool			dma_pending;
 	struct completion	done;
@@ -2127,10 +2131,24 @@ int brcmnand_probe(struct platform_device *pdev, struct brcmnand_soc *soc)
 	if (IS_ERR(ctrl->nand_base))
 		return PTR_ERR(ctrl->nand_base);
 
+	/* Enable clock before using NAND registers */
+	ctrl->clk = devm_clk_get(dev, "nand");
+	if (!IS_ERR(ctrl->clk)) {
+		ret = clk_prepare_enable(ctrl->clk);
+		if (ret)
+			return ret;
+	} else {
+		ret = PTR_ERR(ctrl->clk);
+		if (ret == -EPROBE_DEFER)
+			return ret;
+
+		ctrl->clk = NULL;
+	}
+
 	/* Initialize NAND revision */
 	ret = brcmnand_revision_init(ctrl);
 	if (ret)
-		return ret;
+		goto err;
 
 	/*
 	 * Most chips have this cache at a fixed offset within 'nand' block.
@@ -2139,8 +2157,10 @@ int brcmnand_probe(struct platform_device *pdev, struct brcmnand_soc *soc)
 	res = platform_get_resource_byname(pdev, IORESOURCE_MEM, "nand-cache");
 	if (res) {
 		ctrl->nand_fc = devm_ioremap_resource(dev, res);
-		if (IS_ERR(ctrl->nand_fc))
-			return PTR_ERR(ctrl->nand_fc);
+		if (IS_ERR(ctrl->nand_fc)) {
+			ret = PTR_ERR(ctrl->nand_fc);
+			goto err;
+		}
 	} else {
 		ctrl->nand_fc = ctrl->nand_base +
 				ctrl->reg_offsets[BRCMNAND_FC_BASE];
@@ -2150,8 +2170,10 @@ int brcmnand_probe(struct platform_device *pdev, struct brcmnand_soc *soc)
 	res = platform_get_resource_byname(pdev, IORESOURCE_MEM, "flash-dma");
 	if (res) {
 		ctrl->flash_dma_base = devm_ioremap_resource(dev, res);
-		if (IS_ERR(ctrl->flash_dma_base))
-			return PTR_ERR(ctrl->flash_dma_base);
+		if (IS_ERR(ctrl->flash_dma_base)) {
+			ret = PTR_ERR(ctrl->flash_dma_base);
+			goto err;
+		}
 
 		flash_dma_writel(ctrl, FLASH_DMA_MODE, 1); /* linked-list */
 		flash_dma_writel(ctrl, FLASH_DMA_ERROR_STATUS, 0);
@@ -2160,13 +2182,16 @@ int brcmnand_probe(struct platform_device *pdev, struct brcmnand_soc *soc)
 		ctrl->dma_desc = dmam_alloc_coherent(dev,
 						     sizeof(*ctrl->dma_desc),
 						     &ctrl->dma_pa, GFP_KERNEL);
-		if (!ctrl->dma_desc)
-			return -ENOMEM;
+		if (!ctrl->dma_desc) {
+			ret = -ENOMEM;
+			goto err;
+		}
 
 		ctrl->dma_irq = platform_get_irq(pdev, 1);
 		if ((int)ctrl->dma_irq < 0) {
 			dev_err(dev, "missing FLASH_DMA IRQ\n");
-			return -ENODEV;
+			ret = -ENODEV;
+			goto err;
 		}
 
 		ret = devm_request_irq(dev, ctrl->dma_irq,
@@ -2175,7 +2200,7 @@ int brcmnand_probe(struct platform_device *pdev, struct brcmnand_soc *soc)
 		if (ret < 0) {
 			dev_err(dev, "can't allocate IRQ %d: error %d\n",
 					ctrl->dma_irq, ret);
-			return ret;
+			goto err;
 		}
 
 		dev_info(dev, "enabling FLASH_DMA\n");
@@ -2199,7 +2224,8 @@ int brcmnand_probe(struct platform_device *pdev, struct brcmnand_soc *soc)
 	ctrl->irq = platform_get_irq(pdev, 0);
 	if ((int)ctrl->irq < 0) {
 		dev_err(dev, "no IRQ defined\n");
-		return -ENODEV;
+		ret = -ENODEV;
+		goto err;
 	}
 
 	/*
@@ -2223,7 +2249,7 @@ int brcmnand_probe(struct platform_device *pdev, struct brcmnand_soc *soc)
 	if (ret < 0) {
 		dev_err(dev, "can't allocate IRQ %d: error %d\n",
 			ctrl->irq, ret);
-		return ret;
+		goto err;
 	}
 
 	for_each_available_child_of_node(dn, child) {
@@ -2233,7 +2259,8 @@ int brcmnand_probe(struct platform_device *pdev, struct brcmnand_soc *soc)
 			host = devm_kzalloc(dev, sizeof(*host), GFP_KERNEL);
 			if (!host) {
 				of_node_put(child);
-				return -ENOMEM;
+				ret = -ENOMEM;
+				goto err;
 			}
 			host->pdev = pdev;
 			host->ctrl = ctrl;
@@ -2249,10 +2276,17 @@ int brcmnand_probe(struct platform_device *pdev, struct brcmnand_soc *soc)
 	}
 
 	/* No chip-selects could initialize properly */
-	if (list_empty(&ctrl->host_list))
-		return -ENODEV;
+	if (list_empty(&ctrl->host_list)) {
+		ret = -ENODEV;
+		goto err;
+	}
 
 	return 0;
+
+err:
+	clk_disable_unprepare(ctrl->clk);
+	return ret;
+
 }
 EXPORT_SYMBOL_GPL(brcmnand_probe);
 
@@ -2264,6 +2298,8 @@ int brcmnand_remove(struct platform_device *pdev)
 	list_for_each_entry(host, &ctrl->host_list, node)
 		nand_release(&host->mtd);
 
+	clk_disable_unprepare(ctrl->clk);
+
 	dev_set_drvdata(&pdev->dev, NULL);
 
 	return 0;
Signature · 4 lines
2.1.4

-- 
Simon Arlott
#2 lore raw

PATCH 3/3 mtd: brcmnand: Add support for the BCM6368

In reply to Simon Arlott

The BCM6368 has a NAND interrupt register with combined status and enable registers.

As the BCM6328, BCM6362 and BCM6368 all use v2.1 controllers, the first variant that will work with this driver is the BCM63268 using a v4.0 controller.

Set up the device by disabling and acking all interrupts, then handle the CTRL_READY interrupt.

---
 drivers/mtd/nand/brcmnand/Makefile       |   1 +
 drivers/mtd/nand/brcmnand/bcm6368_nand.c | 145 +++++++++++++++++++++++++++++++
 2 files changed, 146 insertions(+)
 create mode 100644 drivers/mtd/nand/brcmnand/bcm6368_nand.c
drivers/mtd/nand/brcmnand/Makefile +1 -0
index 3b1fbfd..b28ffb59 100644
@@ -2,5 +2,6 @@
 # more specific iproc_nand.o, for instance
 obj-$(CONFIG_MTD_NAND_BRCMNAND)		+= iproc_nand.o
 obj-$(CONFIG_MTD_NAND_BRCMNAND)		+= bcm63138_nand.o
+obj-$(CONFIG_MTD_NAND_BRCMNAND)		+= bcm6368_nand.o
 obj-$(CONFIG_MTD_NAND_BRCMNAND)		+= brcmstb_nand.o
 obj-$(CONFIG_MTD_NAND_BRCMNAND)		+= brcmnand.o
drivers/mtd/nand/brcmnand/bcm6368_nand.c new file +145 -0

145 lines not on this page · raw message

Signature · 8 lines
2.1.4

-- 
Simon Arlott
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html