sunxi:Correct the LDO settings for sinovoip-bpi-m3 board

Hello,

I forgot to post this patch, Thanks to Kevin Chua Soon Jia <[email protected]> who reported that latest mainline u-boot fail to boot and reminded me to post it.

For Banana-pi m3, ALDO must not be set to zero, default settings are same as mentioned Sinovoip Bpi-m3 schematic.

Vishnu Patekar (1):
sunxi: sinovoip-bpi-m3: drop LDO settings from defconfig

 configs/Sinovoip_BPI_M3_defconfig | 3 ---
 1 file changed, 3 deletions(-)

1.9.1

Kconfig default settings are same as mentioned Sinovoip Bpi-m3 schematic.

As axp818 ALDO support is enabled, it causes bpi-m3 fail to boot if ALDOs are set to 0.

---
 configs/Sinovoip_BPI_M3_defconfig | 3 ---
 1 file changed, 3 deletions(-)

index b96be50..eae7191 100644
@@ -21,6 +21,3 @@ CONFIG_AXP_DCDC2_VOLT=900
 CONFIG_AXP_DCDC3_VOLT=900
 CONFIG_AXP_DCDC4_VOLT=0
 CONFIG_AXP_DCDC5_VOLT=1200
-CONFIG_AXP_ALDO2_VOLT=0
-CONFIG_AXP_ALDO3_VOLT=0
-CONFIG_AXP_DLDO4_VOLT=0

1.9.1

Hello Hans,
This patch is base on u-boot-sunxi next.

I see it's far behind the u-boot master.
Aren't we using u-boot-sunxi next ?(
http://git.denx.de/?p=u-boot/u-boot-sunxi.git;a=shortlog;h=refs/heads/next)

Regards,
Vishnu

Hi,

I usually push to next when preparing a pull-req, and I've not submitted a pull-req in a while (I will do so soon).

About your patch, the initial mail only had a cover letter and seems to missing the actual patch, can you please resend it ?

Regards,

Hans

Hi,

On 22-03-16 09:19, Hans de Goede wrote:

<snip>

Never mind, my bad I've found it.

Regards,

Hans

Hi,

Thanks, applied.

Regards,

Hans