nvme/quirk: Add a delay before checking for adapter readiness

index 1a51584..7b89f0e 100644
@@ -991,6 +991,15 @@ int nvme_disable_ctrl(struct nvme_ctrl *ctrl, u64 cap)
 	ret = ctrl->ops->reg_write32(ctrl, NVME_REG_CC, ctrl->ctrl_config);
 	if (ret)
 		return ret;
+
+	/* Checking for ctrl->tagset is a trick to avoid sleeping on module
+	 * load, since we only need the quirk on reset_controller. Notice
+	 * that the HGST device needs this delay only in firmware activation
+	 * procedure; unfortunately we have no (easy) way to verify this.
+	 */
+	if ((ctrl->quirks & NVME_QUIRK_DELAY_BEFORE_CHK_RDY) && ctrl->tagset)
+		msleep(NVME_QUIRK_DELAY_AMOUNT);
+
 	return nvme_wait_ready(ctrl, cap, false);
 }
 EXPORT_SYMBOL_GPL(nvme_disable_ctrl);

index 1daa048..97ac7d1 100644
@@ -65,8 +65,21 @@ enum nvme_quirks {
 	 * logical blocks.
 	 */
 	NVME_QUIRK_DISCARD_ZEROES		= (1 << 2),
+
+	/*
+	 * The controller needs a delay before starts checking the device
+	 * readiness, which is done by reading the NVME_CSTS_RDY bit.
+	 */
+	NVME_QUIRK_DELAY_BEFORE_CHK_RDY		= (1 << 3),
 };
 
+/* The below value is the specific amount of delay needed before checking
+ * readiness in case of the PCI_DEVICE(0x1c58, 0x0003), which needs the
+ * NVME_QUIRK_DELAY_BEFORE_CHK_RDY quirk enabled. The value (in ms) was
+ * found empirically.
+ */
+#define NVME_QUIRK_DELAY_AMOUNT		2000
+
 enum nvme_ctrl_state {
 	NVME_CTRL_NEW,
 	NVME_CTRL_LIVE,

index befac5b..238cf47 100644
@@ -2122,6 +2122,8 @@ static const struct pci_device_id nvme_id_table[] = {
 				NVME_QUIRK_DISCARD_ZEROES, },
 	{ PCI_VDEVICE(INTEL, 0x5845),	/* Qemu emulated controller */
 		.driver_data = NVME_QUIRK_IDENTIFY_CNS, },
+	{ PCI_DEVICE(0x1c58, 0x0003),	/* HGST adapter */
+		.driver_data = NVME_QUIRK_DELAY_BEFORE_CHK_RDY, },
 	{ PCI_DEVICE_CLASS(PCI_CLASS_STORAGE_EXPRESS, 0xffffff) },
 	{ PCI_DEVICE(PCI_VENDOR_ID_APPLE, 0x2001) },
 	{ 0, }