ARM: dts: add PM8058 LEDs to the APQ8060 Dragonboard

This adds the PM8058 LEDs as used in the platform.

Cc linux-arm-msm at vger.kernel.org

Cc linux-leds at vger.kernel.org

Cc Andy Gross <[email protected]>

Cc Stephen Boyd <[email protected]>

Cc Jacek Anaszewski <[email protected]>

Reviewed-by Bjorn Andersson <[email protected]>

Signed-off-by Linus Walleij <[email protected]>

---
ChangeLog v1->v2:
- Rename the infrared LED to "pm8058:infrared:proximitysensor"

---
  arch/arm/boot/dts/qcom-apq8060-dragonboard.dts | 39 ++++++++++++++++++++++++++
  1 file changed, 39 insertions(+)

arch/arm/boot/dts/qcom-apq8060-dragonboard.dts +32 -0

index 0abc93e5bb00..6c0038398ef2 100644
@@ -239,6 +239,45 @@
  						};
  					};
  				};
+
+				led at 48 {
+					/*
+					 * The keypad LED @0x48 is routed to
+					 * the sensor board where it is
+					 * connected to an infrared LED
+					 * SFH4650 (60mW, @850nm) next to the
+					 * ambient light and proximity sensor
+					 * Capella Microsystems CM3605.
+					 */
+					compatible = "qcom,pm8058-keypad-led";
+					reg = <0x48>;
+					label = "pm8058:infrared:proximitysensor";
+					default-state = "off";
+				};
+				led at 131 {
+					compatible = "qcom,pm8058-led";
+					reg = <0x131>;
+					label = "pm8058:red";
+					default-state = "off";
+				};
+				led at 132 {
+					/*
+					 * This is actually green too on my
+					 * board, but documented as yellow.
+					 */
+					compatible = "qcom,pm8058-led";
+					reg = <0x132>;
+					label = "pm8058:yellow";
+					default-state = "off";
+					linux,default-trigger = "mmc0";
+				};