Skip to contentSkip to conversation

Iptables is resetting

DISCUSSION Joseph Nicholson 3 participants 3 messages Aug 4, 2005 – Aug 5, 2005

lore
Share & tools
lore
#0 lore raw

I have been seeing an issue lately when using Iptables on a Fedora Core 3 box. The version number is 1.2.11. Some of my users have been complaining that sometimes the connection will stop working. If I go in the box and re-apply the config then everything will start working again. I have listed the tables before I re-applied and see that they are all still there, but for some reason they stop working. I have the following NAT rules running:

Chain PREROUTING (policy ACCEPT)

target     prot opt source               destination
DNAT       all  --  0.0.0.0/0            1.2.3.4       to:10.65.0.4
DNAT       all  --  0.0.0.0/0            1.2.3.5       to:10.65.1.5

Chain POSTROUTING (policy ACCEPT)

target     prot opt source               destination
SNAT       all  --  10.65.0.4            0.0.0.0/0           to:1.2.3.4
SNAT       all  --  10.65.1.5            0.0.0.0/0           to:1.2.3.5
SNAT       all  --  0.0.0.0/0            0.0.0.0/0           to:1.2.3.3

1.2.3.4 is a Cisco pix running a vpn tunnel to a remote location. 1.2.3.5 is a desktop PC I use for remote management. 1.2.3.3 is the eth0 (outside interface) of the linux box.

This box is setup as a router.

When the VPN tunnel that 1.2.3.4 has is up and running I can do a constant ping to the inside interface of the Pix. Several times a day it will stop responding to pings. If I go and re-apply the iptables using webmin, then it will start working again.

The last SNAT rules is for the 800+ users I have running on the inside of this network.

I tried looking to see if this was a known issue, but I could not find any info on it. It is possible that since I am still fairly new to iptables then i might not have been looking for the answer in the correct place.

I read the NAT tutorials listed on the netfilter site and I am confident that I have my rules setup properly.

I greatly appreciate any help in advance.

Signature · 1 line
Joseph Nicholson
#1 lore raw
Quoted 4 lines

I have been seeing an issue lately when using Iptables on a Fedora Core 3 box. The version number is 1.2.11. Some of my users have been complaining that sometimes the connection will stop working. If I go

Maybe something is calling iptables -F spuriously?

Jan Engelhardt

#2 lore raw
Quoted 1 line · Jan Engelhardt

Maybe something is calling iptables -F spuriously?

Quoted 2 lines · Joseph Nicholson

I have listed the tables before I re-applied and see that they are all still there, but for some reason they stop working.

You mention that your userbase is large. Wild guess, but could the conntrack table be filling up or could it be some other load-based thing? I believe /proc/net/ip_conntrack stores state of tracked connections.