U-Boot on 440EP Bamboo board, anybody succeed?
Hi,
I'm trying to run U-Boot 1.1.4 on original 440EP Bamboo board and have two major problems:
1. Ethernets don't work, just "Net: No ethernet found" on boot. In PIBS works.
2. When trying to boot uImage (loaded via USB, as eth doesn't work), it just hang after "Uncompressing Kernel Image ... OK". The same bzImage runs in PIBS. U-Boot 1.1.4, Linux 2.6.16, compiled with gcc 3.4.5.
Does anybody succeed to run U-Boot on this board?
thanks in advance,
--
Andriy Korud
Quoted 2 lines · In message <[email protected]> you…
I'm trying to run U-Boot 1.1.4 on original 440EP Bamboo board and have
Which git commit ID is your version of U-Boot?
Quoted 1 line
Does anybody succeed to run U-Boot on this board?
Yes, of course. We have U-Boot running fine on this board. You can find working images on our FTP server, see ftp://ftp.denx.de/pub/u-boot/images/amcc/bamboo/
Best regards,
Wolfgang Denk
Signature · 4 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
What is mind? No matter. What is matter? Never mind.
-- Thomas Hewitt Key, 1799-1875Hi Andriy,
Quoted 3 lines · Andriy Korud
I'm trying to run U-Boot 1.1.4 on original 440EP Bamboo board and have two
major problems: 1. Ethernets don't work, just "Net: No ethernet found" on
boot.
You have to set the MAC addresse(s) and reset the board. After this both enet devices will be available.
Quoted 4 lines
In PIBS works. 2. When trying to boot uImage (loaded via USB, as eth doesn't work), it just hang after "Uncompressing Kernel Image ... OK". The same bzImage runs in PIBS. U-Boot 1.1.4, Linux 2.6.16, compiled with gcc 3.4.5.
Please give the DENX linux images a try:
ftp://ftp.denx.de/pub/linux/images/amcc/bamboo/
They definitely work here on a baboo.
Best regards,
Stefan