6pack trying to resynch TNC message
I see this message if the TNC gets turned off or the RS-232 cable gets pulled. Even though all has been restored it is to no avail, it still sets there and sends the trying to resynch message. Is there a workaround or just keep the power on the TNC and make sure the Rs-232 does not get interrupted?
Seriously, 6pack is indeed a much better solution than KISS. I just ran into this problem when the TNC got powered down and back up,
I guess that the computer is trying to do what the message says but it is not working.
Any idea of what I can do to make sure that the tnc does get re-synched?
Signature · 5 lines
Chuck Hast To paraphrase my flight instructor; "the only dumb question is the one you DID NOT ask resulting in my going out and having to identify your bits and pieces in the midst of torn and twisted metal."
Quoted 6 lines · Chuck Hast
I see this message if the TNC gets turned off or the RS-232 cable gets pulled. Even though all has been restored it is to no avail, it still sets there and sends the trying to resynch message. Is there a workaround or just keep the power on the TNC and make sure the Rs-232 does not get interrupted?
Quoted 7 lines
Seriously, 6pack is indeed a much better solution than KISS. I just ran into this problem when the TNC got powered down and back up,
I guess that the computer is trying to do what the message says but it is not working.
Any idea of what I can do to make sure that the tnc does get re-synched?
I've fixed the driver's excessive verbosity about resyncing in the latest version of the 6pack driver which currently is waiting in -mm to be merged. So unless catastrophes happen it's going to be in 2.6.10 or 2.6.11.
The patch shouldn't make a difference for your case but I'm going to take a look at it once the latest patch is finally merged.
73 de DL5RB op Ralf
--
Loc. JN47BS / CQ 14 / ITU 28 / DOK A21