Skip to contentSkip to conversation

Ultra320 drive detected as narrow SCSI by adapter

DISCUSSION Israel Mouton 2 participants 5 messages Sep 25, 2006 SCSI

lore
Share & tools
lore
#0 lore raw

While my adapter card is scanning for devices, it detects my Maxtor Atlas V as a narrow drive; however, it is an Ultra320. This setup was working fine until a few days ago, when adapter began detecting it as a narrow SCSI. Now the disk can only transfer at about 10-20MB/s. My adapter card is an LSI 53C1030 and is PCI-X. If any one can help, I will be extremely grateful. I also included my dmesg concerning SCSI devices output below.

mptbase: Initiating ioc0 bringup
ioc0: 53C1030: Capabilities={Initiator}
scsi0 : ioc0: LSI53C1030, FwRev=01030f00h, Ports=1, MaxQ=222, IRQ=9
Vendor: MAXTOR Model: ATLAS10K5_147SCA Rev: JNX0
Type: Direct-Access ANSI SCSI revision: 03
SCSI device sda: 287332384 512-byte hdwr sectors (147114 MB)
sda: Write Protect is off
sda: Mode Sense: bf 00 10 08
SCSI device sda: drive cache: write back w/ FUA
SCSI device sda: 287332384 512-byte hdwr sectors (147114 MB)
sda: Write Protect is off
sda: Mode Sense: bf 00 10 08
SCSI device sda: drive cache: write back w/ FUA
sda: sda1 sda2 < sda5 sda6 >
sd 0:0:0:0: Attached scsi disk sda
sd 0:0:0:0: Attached scsi generic sg0 type 0

Signature · 2 lines
View this message in context: http://www.nabble.com/Ultra320-drive-detected-as-narrow-SCSI-by-adapter-tf2328646.html#a6478431
Sent from the linux-scsi mailing list archive at Nabble.com.
#1 lore raw
Quoted 4 lines · Israel Mouton

scsi0 : ioc0: LSI53C1030, FwRev=01030f00h, Ports=1, MaxQ=222, IRQ=9
Vendor: MAXTOR Model: ATLAS10K5_147SCA Rev: JNX0
Type: Direct-Access ANSI SCSI revision: 03
SCSI device sda: 287332384 512-byte hdwr sectors (147114 MB)

It's not doing domain validation, which configures the device ... that could be a driver bug, but I know of no outstanding problems in that area.

You can try to re-trigger it with

echo 1 > /sys/class/spi_transport/target0:0:0/revalidate

and see what happens?

Thanks,

James

#2 lore raw

I don't seem to have a "/sys/class/spi_transport/" directory. When the system boots the LSI board detects it as a narrow. I was wondering if it is perhaps possible to reconfigure it under Linux at all?

Quoted 27 lines · James Bottomley
Quoted 4 lines · Israel Mouton

scsi0 : ioc0: LSI53C1030, FwRev=01030f00h, Ports=1, MaxQ=222, IRQ=9
Vendor: MAXTOR Model: ATLAS10K5_147SCA Rev: JNX0
Type: Direct-Access ANSI SCSI revision: 03
SCSI device sda: 287332384 512-byte hdwr sectors (147114 MB)

It's not doing domain validation, which configures the device ... that could be a driver bug, but I know of no outstanding problems in that area.

You can try to re-trigger it with

echo 1 > /sys/class/spi_transport/target0:0:0/revalidate

and see what happens?

Thanks,

James

-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html

Signature · 2 lines
View this message in context: http://www.nabble.com/Ultra320-drive-detected-as-narrow-SCSI-by-adapter-tf2328646.html#a6479563
Sent from the linux-scsi mailing list archive at Nabble.com.
#3 lore raw
Quoted 3 lines · Israel Mouton

I don't seem to have a "/sys/class/spi_transport/" directory. When the system boots the LSI board detects it as a narrow. I was wondering if it is perhaps possible to reconfigure it under Linux at all?

Erm, what kernel is this? The generic transport class, which does allow you to configure this type of thing has been present in the kernel since 2.6.16

James

#4 lore raw

It is 2.6.16; however, it is the Debian version. I did compile it from source. Perhaps there is a chance I left something unchecked I should have compiled in?

Quoted 19 lines · James Bottomley
Quoted 4 lines · Israel Mouton

I don't seem to have a "/sys/class/spi_transport/" directory. When the system boots the LSI board detects it as a narrow. I was wondering if it is
perhaps possible to reconfigure it under Linux at all?

Erm, what kernel is this? The generic transport class, which does allow you to configure this type of thing has been present in the kernel since 2.6.16

James

-
To unsubscribe from this list: send the line "unsubscribe linux-scsi" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html

Signature · 2 lines
View this message in context: http://www.nabble.com/Ultra320-drive-detected-as-narrow-SCSI-by-adapter-tf2328646.html#a6480232
Sent from the linux-scsi mailing list archive at Nabble.com.