Skip to contentSkip to conversation

SMBIOS entry point

DISCUSSION Heinrich Schuchardt 3 participants 3 messages Oct 15, 2020 – Oct 19, 2020

lore
Share & tools
lore
#0 lore raw

According to

DSP0134, 3.4.0, System Management BIOS (SMBIOS) Reference Specification
https://www.dmtf.org/sites/default/files/standards/documents/DSP0134_3.4.0.pdf

our struct smbios_entry is an SMBIOS 2.1 (32-bit) Entry Point structure. This structure requires that the SMBIOS table is located below 4 GiB.

Some boards (ZynqMP, Versal) do not have memory mapped in the low 4 GiB of the address space. So shouldn't we use the SMBIOS 3.0 (64-bit) Entry Point structure?

Is there any restriction on 32bit boards that would stop us from using the SMBIOS 3.0 Entry Point?

Best regards

Heinrich

#1 lore raw
Quoted 11 lines

From: Heinrich Schuchardt <[email protected]>
Date: Thu, 15 Oct 2020 19:18:21 +0200

According to

DSP0134, 3.4.0, System Management BIOS (SMBIOS) Reference Specification
https://www.dmtf.org/sites/default/files/standards/documents/DSP0134_3.4.0.pdf

our struct smbios_entry is an SMBIOS 2.1 (32-bit) Entry Point structure. This structure requires that the SMBIOS table is located below 4 GiB.

Quoted 6 lines

Some boards (ZynqMP, Versal) do not have memory mapped in the low 4 GiB of the address space. So shouldn't we use the SMBIOS 3.0 (64-bit) Entry Point structure?

Is there any restriction on 32bit boards that would stop us from using the SMBIOS 3.0 Entry Point?

I don't think so. You'll have to advertise it using the SMBIOS3_TABLE_GUID though. And maybe some older OSes don't support it yet though. Apparently providing both the 32-bit and 64-bit entry point is allowed.

Other arm64 UEFI implementations (EDK2 and whatever Lenovo/Ampere provides on their systems) do provide the SMBIOS 3.0 entry point and currently that is all that OpenBSD checks for on arm64.

#2 lore raw
In reply to Heinrich Schuchardt

Hi Heinrich,

Quoted 11 lines · Heinrich Schuchardt

According to

DSP0134, 3.4.0, System Management BIOS (SMBIOS) Reference Specification
https://www.dmtf.org/sites/default/files/standards/documents/DSP0134_3.4.0.pdf

our struct smbios_entry is an SMBIOS 2.1 (32-bit) Entry Point structure. This structure requires that the SMBIOS table is located below 4 GiB.

Some boards (ZynqMP, Versal) do not have memory mapped in the low 4 GiB of the address space. So shouldn't we use the SMBIOS 3.0 (64-bit) Entry Point structure?

Just to make it clear. Yes there are configurations which can be done like this that there is no memory in low 4GB.

Thanks,
Michal