Skip to contentSkip to conversation

2.4.2-pre3 and 2.4.1-ac9 sound corruption

DISCUSSION Ole Andre Vadla Ravnaas 2 participants 3 messages Feb 10, 2001 – Feb 11, 2001

lore
Share & tools
lore
#0 lore raw

I've been using vanilla 2.4.1 with no problems, with my soundcard (SB PCI 128 / es1370) sharing IRQ with the USB-controller (this is an Abit KT7-RAID motherboard). This is what /proc/interrupts tells me:
CPU0

  0:     130808          XT-PIC  timer
  1:        564          XT-PIC  keyboard
  2:          0          XT-PIC  cascade
  7:      12256          XT-PIC  usb-uhci, usb-uhci, es1370
 10:        503          XT-PIC  eth0
 11:       2916          XT-PIC  ide2, ide3
 14:         16          XT-PIC  ide0
 15:         11          XT-PIC  ide1
NMI:          0
ERR:          0

After upgrading to 2.4.2-pre3 I get sound corruption (I believe this problem has existed since pre2, since I suspect the " - driver sync up with Alan" part of the changes in pre2 to be the source of the problem. I've also tried 2.4.1-ac9, which gives me the exact same problems (sound corruption, really "weird" sound). Hope this is enough info to at least track down some problem if it hasn't been done already.

I'm not subscribed to the linux kernel mailing-list, so please CC to me any follow-ups and I'll do my best to track down the problem if more info about my system/configuration is needed.

Best regards,
Ole André Vadla Ravnås

#1 lore raw
Quoted 3 lines

After upgrading to 2.4.2-pre3 I get sound corruption (I believe this proble= m has existed since pre2, since I suspect the " - driver sync up with Alan"=
part of the changes in pre2 to be the source of the problem. I've also tri=

No es1370 changes went in

Quoted 2 lines

ed 2.4.1-ac9, which gives me the exact same problems (sound corruption, rea= lly "weird" sound).

Are you using XFree86 4.0 on a matrox card ?

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/

#2 lore raw
Quoted 1 line

Are you using XFree86 4.0 on a matrox card ?

No, it's an nVIDIA Riva TNT2 Ultra 32 MB AGP (card manufacturer: Creative). But these problems are not related to X, as they are the same whether I use mpg123 in a plain console or xmms in X. But, I've also tried something else, I compiled a kernel with absolutely NO sound support, then downloaded OSS from www.opensound.com and installed it. The exact _same_ problems occured. So now I'm suspecting the IRQ-sharing with the two USB UHCI-controllers to be the problem (worked fine with 2.4.1 "vanilla" though, where the same devices were sharing the same interrupts..). Have there been any changes on that part? (USB UHCI driver IRQ-sharing etc.)

(Please CC a copy to me as I'm not subscribed to the linux kernel mailing-list right now)

Regards
Ole André Vadla Ravnås