Skip to contentSkip to conversation

Bluetooth: btmtksdio: Stop discarding the hardware device id

PATCH Applied Chris Lu 3 participants 5 messages Aug 25 – Aug 31

Subsystems (2)
lore
Share & tools
lore

Chris Lu

author
#0 lore raw

cover Bluetooth: btmtksdio: Stop discarding the hardware device id

btmtksdio_setup() reads the device id from register 0x70010200 and then throws it away twice: an snprintf() overwrites the filename that btmtk_fw_get_filename() derived from it, and mt79xx_setup() passes a hardcoded 0 on to btmtk_setup_firmware_79xx().

Neither matters on supported hardware, since the device ids that would make a difference - 0x6639, 0x7925 and a flavored 0x7961 - all belong to parts with no SDIO interface. So this targets bluetooth-next with no
Fixes: tags. What it buys is that the two functions stop silently ignoring their input, which is a trap for the next chip added to this driver.

Both patches come from a larger MT7928 series [1], where they were described as fixing firmware load failures on MT6639, MT7925 and MT7928. That does not hold for the SDIO driver and has been dropped.

Tested on a Chromebook with MT7921S, whose chip id register reports 0x7961: before and after, the driver requests mediatek/BT_RAM_CODE_MT7961_1_2_hdr.bin, the firmware loads, and the controller powers on and connects to an A2DP device.

[1] https://lore.kernel.org/linux-bluetooth/[email protected]/

Chris Lu (2):
Bluetooth: btmtksdio: Remove redundant firmware filename override
Bluetooth: btmtksdio: Pass the hardware device id to mt79xx_setup()

 drivers/bluetooth/btmtksdio.c | 13 +++++--------
 1 file changed, 5 insertions(+), 8 deletions(-)
Signature · 1 line
2.45.2
author
#1 lore raw

PATCH 1/2 Bluetooth: btmtksdio: Remove redundant firmware filename override

btmtksdio_setup() derives the firmware filename with btmtk_fw_get_filename() and then overwrites it with an snprintf() that open-codes that helper's fallback format. Commit 7f935b21bee4 ("Bluetooth:
btmtk: apply the common btmtk_fw_get_filename") added the helper call without removing the snprintf() it was meant to replace.

None of the device ids the helper special-cases can appear here: 0x6639, 0x7925 and the flavored 0x7961 belong to parts with no SDIO interface, and btmtksdio_setup() passes a flavor of 0 accordingly. The helper always falls through to the snprintf()'s own format, so both produce the same string and removing it is a no-op.

Remove it anyway, since it silently defeats the helper for any device id the helper special-cases.

Assisted-by Claude:claude-opus-5
---
 drivers/bluetooth/btmtksdio.c | 3 ---
 1 file changed, 3 deletions(-)
drivers/bluetooth/btmtksdio.c +0 -3
index b7f0be7fc42a..a5709cecd4b5 100644
@@ -1162,9 +1162,6 @@ static int btmtksdio_setup(struct hci_dev *hdev)
 		btmtk_fw_get_filename(fwname, sizeof(fwname), dev_id,
 				      fw_version, 0);
 
-		snprintf(fwname, sizeof(fwname),
-			 "mediatek/BT_RAM_CODE_MT%04x_1_%x_hdr.bin",
-			 dev_id & 0xffff, (fw_version & 0xff) + 1);
 		err = mt79xx_setup(hdev, fwname);
 		if (err < 0)
 			return err;
Signature · 1 line
2.45.2
#2 lore raw

This is automated email and please do not reply to this email!

Dear submitter,

Thank you for submitting the patches to the linux bluetooth mailing list. This is a CI test results with your patch series:
PW Link:https://patchwork.kernel.org/project/bluetooth/list/?series=1151231

---Test result---

Test Summary:

CheckPatch                    PASS      1.13 seconds
VerifyFixes                   PASS      0.11 seconds
VerifySignedoff               PASS      0.10 seconds
GitLint                       PASS      0.51 seconds
SubjectPrefix                 PASS      0.20 seconds
BuildKernel                   PASS      23.49 seconds
CheckAllWarning               PASS      25.63 seconds
CheckSparse                   PASS      23.78 seconds
BuildKernel32                 PASS      24.52 seconds
CheckKernelLLVM               SKIP      0.00 seconds
TestRunnerSetup               PASS      401.40 seconds
IncrementalBuild              PASS      24.67 seconds

Details
##############################
Test: CheckKernelLLVM - SKIP
Desc: Build kernel with LLVM + context analysis
Output:
Clang not found

https://github.com/bluez/bluetooth-next/pull/650

---
Regards,
Linux Bluetooth

author
#3 lore raw

PATCH 2/2 Bluetooth: btmtksdio: Pass the hardware device id to mt79xx_setup()

In reply to Chris Lu

mt79xx_setup() passes a hardcoded 0 to btmtk_setup_firmware_79xx(), discarding the device id that btmtksdio_setup() has just read from register 0x70010200. That argument only gates the section filtering for MT6639, which has no SDIO interface, so this is a no-op on supported hardware and carries no Fixes: tag.

Pass the value that has already been read, matching the USB path. Declare dev_id as u32 while at it, since that is what btmtksdio_mtk_reg_read() writes through the pointer.

Assisted-by Claude:claude-opus-5
---
 drivers/bluetooth/btmtksdio.c | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)
drivers/bluetooth/btmtksdio.c +5 -5
index a5709cecd4b5..fe4ca9395aa3 100644
@@ -899,14 +899,14 @@ static int mt76xx_setup(struct hci_dev *hdev, const char *fwname)
 	return 0;
 }
 
-static int mt79xx_setup(struct hci_dev *hdev, const char *fwname)
+static int mt79xx_setup(struct hci_dev *hdev, const char *fwname, u32 dev_id)
 {
 	struct btmtksdio_dev *bdev = hci_get_drvdata(hdev);
 	struct btmtk_hci_wmt_params wmt_params;
 	u8 param = 0x1;
 	int err;
 
-	err = btmtk_setup_firmware_79xx(hdev, fwname, mtk_hci_wmt_sync, 0);
+	err = btmtk_setup_firmware_79xx(hdev, fwname, mtk_hci_wmt_sync, dev_id);
 	if (err < 0) {
 		bt_dev_err(hdev, "Failed to setup 79xx firmware (%d)", err);
 		return err;
@@ -1119,8 +1119,8 @@ static int btmtksdio_setup(struct hci_dev *hdev)
 	ktime_t calltime, delta, rettime;
 	unsigned long long duration;
 	char fwname[64];
-	int err, dev_id;
-	u32 fw_version = 0, val;
+	int err;
+	u32 dev_id, fw_version = 0, val;
 
 	calltime = ktime_get();
 	set_bit(BTMTKSDIO_HW_TX_READY, &bdev->tx_state);
@@ -1162,7 +1162,7 @@ static int btmtksdio_setup(struct hci_dev *hdev)
 		btmtk_fw_get_filename(fwname, sizeof(fwname), dev_id,
 				      fw_version, 0);
 
-		err = mt79xx_setup(hdev, fwname);
+		err = mt79xx_setup(hdev, fwname, dev_id);
 		if (err < 0)
 			return err;
 
Signature · 1 line
2.45.2
#4 lore raw
In reply to Chris Lu
This series was applied to bluetooth/bluetooth-next.git (master) by Luiz Augusto von Dentz <[email protected]>:

Hello:

This series was applied to bluetooth/bluetooth-next.git (master) by Luiz Augusto von Dentz <[email protected]>:

Quoted 5 lines · On Tue, 25 Aug 2026 11:36:32 +0800 you wrote:

btmtksdio_setup() reads the device id from register 0x70010200 and then throws it away twice: an snprintf() overwrites the filename that btmtk_fw_get_filename() derived from it, and mt79xx_setup() passes a hardcoded 0 on to btmtk_setup_firmware_79xx().

Quoted 7 lines

Neither matters on supported hardware, since the device ids that would make a difference - 0x6639, 0x7925 and a flavored 0x7961 - all belong to parts with no SDIO interface. So this targets bluetooth-next with no
Fixes: tags. What it buys is that the two functions stop silently ignoring their input, which is a trap for the next chip added to this driver.

[...]

Here is the summary with links:
- [1/2] Bluetooth: btmtksdio: Remove redundant firmware filename override

    https://git.kernel.org/bluetooth/bluetooth-next/c/4988456a75ea
  - [2/2] Bluetooth: btmtksdio: Pass the hardware device id to mt79xx_setup()
    https://git.kernel.org/bluetooth/bluetooth-next/c/afe439f35546

You are awesome, thank you!

Signature · 2 lines
Deet-doot-dot, I am a bot.
https://korg.docs.kernel.org/patchwork/pwbot.html