eth0 not geting enabled
Quoted 10 lines
Quoted 7 lines
Hi there
I am working on at91sam9260ek. I have put kernel and rfs on dataflash. Now this board boots up but doesn't enable eth0. I searched net and found that if I do a ping it enables phy (MD9161A). But if I do that when there is no network u-boot never recovers. Can someone tell me the way out. It is successful when network is available, though.
What do you mean by 'u-boot never recovers'? It should time out if you try a network operation and are not connected to anything useful.
I expected the same but it doesn't timeout. It just keeps tryingand I have to reset.
regards
Avinash
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.denx.de/pipermail/u-boot/attachments/20080602/f1cb64e4/attachment.htm