2.6.9-rc4-mm1 amd64 Computer crashes on "Freeing unused kernel memory: 200k"
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 6 lines · Espen Fjellvær Olsen
I recently got a new AMD64 3400+ computer, i'm installing gentoo from the gentoo-amd64-livecd.
All goes well, until i try to boot my newly compiled kernel. I't stops at "Freeing unused kernel memory: 200k", no oopses or other information.
I compiled it with gcc-3.3.4.
Does it work with an mainline kernel like 2.6.9rc4 or "2.6.9-final" ?
-Andi
Quoted 9 lines · Andi Kleen
Quoted 6 lines · Espen Fjellvær Olsen
I recently got a new AMD64 3400+ computer, i'm installing gentoo from the gentoo-amd64-livecd.
All goes well, until i try to boot my newly compiled kernel. I't stops at "Freeing unused kernel memory: 200k", no oopses or other information.
I compiled it with gcc-3.3.4.
Quoted 5 lines
Does it work with an mainline kernel like 2.6.9rc4 or "2.6.9-final" ?
-Andi
2.6.9-rc4 won't work either.
I have to boot into a plain 32bit system to run lilo, since it won`t install on gentoo-64, and grub wont work.
Signature · 4 lines
Mvh / Best regards Espen Fjellvær Olsen [email protected] Norway
I'm sending my dmesg and lspci output, and my .config files.
Signature · 4 lines
Mvh / Best regards Espen Fjellvær Olsen [email protected] Norway
Quoted 1 line · Espen Fjellv?r Olsen
I'm sending my dmesg and lspci output, and my .config files.
Does it work with "noapic" or "nolapic" or "acpi=off" or "noapic acpi_irq_balance" ?
-Andi
Quoted 8 lines · Andi Kleen
Quoted 1 line · Espen Fjellv?r Olsen
I'm sending my dmesg and lspci output, and my .config files.
Does it work with "noapic" or "nolapic" or "acpi=off" or "noapic
acpi_irq_balance" ?-Andi
It looks like it was a problem with Lilo or something. I managed to install grub, and then the error went straigth away.
A bit weird tho.
Signature · 4 lines
Mvh / Best regards Espen Fjellvær Olsen [email protected] Norway