Poor responsiveness during disk I/O
My system is unresponsive and nearly unusable during period of high disk I/O. hdparm reports it's using UDMA5 (ATA100), so it looks like everything's up and running. I have a nForce 220-D motherboard (A7N266-VM), a new 160 GB Maxtor ATA133 drive, and an 80 wire IDE cable. I've compiled the amd74xx driver into the kernel.
ATA100 suggests a maximum throughput of 100 MB/s. What I should I
expect to see with hdparm -t? I'm seeing 40 MB/s.
Please cc me in your reply. Thanks,
Shaun
# hdparm -t /dev/hda
/dev/hda:
Timing buffered disk reads: 132 MB in 3.05 seconds = 43.26 MB/sec
# hdparm -v /dev/hda
/dev/hda:
multcount = 16 (on) IO_support = 1 (32-bit) unmaskirq = 1 (on) using_dma = 1 (on) keepsettings = 0 (off) readonly = 0 (off) readahead = 256 (on) geometry = 19929/255/63, sectors = 163928604672, start = 0 # hdparm -i /dev/hda
/dev/hda:
Model=Maxtor 6Y160P0, FwRev=YAR41BW0, SerialNo=Y45EJ8KE Config={ Fixed }
RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=57 BuffType=DualPortCache, BuffSize=7936kB, MaxMultSect=16, MultSect=16 CurCHS=16383/16/63, CurSects=16514064, LBA=yes, LBAsects=268435455 IORDY=on/off, tPIO={min:120,w/IORDY:120}, tDMA={min:120,rec:120} PIO modes: pio0 pio1 pio2 pio3 pio4
DMA modes: mdma0 mdma1 mdma2
UDMA modes: udma0 udma1 udma2 udma3 udma4 *udma5 udma6 AdvancedPM=yes: disabled (255) WriteCache=enabled
Drive conforms to: (null):
* signifies the current active mode
# cat /proc/ide/amd74xx ----------AMD BusMastering IDE Configuration---------------- Driver Version: 2.13 South Bridge: 0000:00:09.0 Revision: IDE 0xc3 Highest DMA rate: UDMA100 BM-DMA base: 0xa800 PCI clock: 33.3MHz -----------------------Primary IDE-------Secondary IDE------ Prefetch Buffer: yes yes Post Write Buffer: yes yes Enabled: yes yes Simplex only: no no Cable Type: 80w 40w -------------------drive0----drive1----drive2----drive3----- Transfer Mode: UDMA PIO UDMA PIO Address Setup: 30ns 90ns 30ns 90ns Cmd Active: 90ns 90ns 90ns 90ns Cmd Recovery: 30ns 30ns 30ns 30ns Data Active: 90ns 330ns 90ns 330ns Data Recovery: 30ns 270ns 30ns 270ns Cycle Time: 20ns 600ns 60ns 600ns Transfer Rate: 99.9MB/s 3.3MB/s 33.3MB/s 3.3MB/s
Quoted 10 lines · Shaun Jackman
My system is unresponsive and nearly unusable during period of high disk I/O. hdparm reports it's using UDMA5 (ATA100), so it looks like everything's up and running. I have a nForce 220-D motherboard (A7N266-VM), a new 160 GB Maxtor ATA133 drive, and an 80 wire IDE cable. I've compiled the amd74xx driver into the kernel.
ATA100 suggests a maximum throughput of 100 MB/s. What I should I
expect to see with hdparm -t? I'm seeing 40 MB/s.Please cc me in your reply. Thanks,
you report a problem to the kernel mailing list suggesting the kernel does something suboptimal, but you entirely forgot to mention which kernel you are using ;) Could you fix that ommision please?
Quoted 3 lines
you report a problem to the kernel mailing list suggesting the kernel does something suboptimal, but you entirely forgot to mention which kernel you are using ;) Could you fix that ommision please?
Sorry, not my best moment.
Linux 2.6.8.1
Here's /proc/interrupts and /proc/dma in addition to the previous information I posted.
Cheers,
Shaun
$ cat /proc/version
Linux version 2.6.8.1 (sjackman@quince) (gcc version 3.3.4 (Debian
1:3.3.4-6sarge1)) #1 Mon Oct 4 13:42:45 PDT 2004
$ cat /proc/interrupts
CPU0
0: 498236341 XT-PIC timer
7: 791002 IO-APIC-edge parport0
8: 111803954 IO-APIC-edge rtc
9: 0 IO-APIC-level acpi
14: 4663149 IO-APIC-edge ide0
15: 25527687 IO-APIC-edge ide1
16: 1581279 IO-APIC-level ivtv0
18: 3558673 IO-APIC-level eth0
21: 3687135 IO-APIC-level ohci_hcd, ohci_hcd, NVidia nForce
NMI: 0
LOC: 498270903
ERR: 0
MIS: 4
$ cat /proc/dma
4: cascadeQuoted 1 line · Shaun Jackman
Linux 2.6.8.1
A "vmstat 1" output during high load would be nice...
Quoted 4 lines · Jan Knutar
Quoted 1 line · Shaun Jackman
Linux 2.6.8.1
A "vmstat 1" output during high load would be nice...
Here I'm running updatedb and opening firefox, which takes about 45 seconds to open. It's running on an Athlon 2400+ XP (2.0 GHz) with 256 MB RAM (PC2100) and 256 MB swap (ATA100).
Thanks,
Shaun
$ vmstat 1 procs -----------memory---------- ---swap-- -----io---- --system-- ----cpu---- r b swpd free buff cache si so bi bo in cs us sy id wa 2 2 95216 44148 30752 20720 180 0 2176 0 1774 2384 89 11 0 0 1 2 95356 45380 28460 20844 560 180 1576 544 1576 2252 69 31 0 0 1 3 95356 44076 28520 21480 192 0 2296 72 1665 3937 90 10 0 0 1 2 95548 45292 26472 22392 0 200 1752 1536 1466 2571 91 9 0 0 2 1 95548 44340 26368 23788 0 0 2524 0 1566 3019 67 33 0 0 4 1 95648 45068 24116 24292 0 424 2232 624 1722 3502 75 25 0 0 1 2 95672 43924 23172 26696 0 36 3876 168 1651 3322 91 9 0 0 1 2 95904 45420 22360 26464 116 296 1572 532 1519 2342 94 6 0 0 1 2 96012 44412 23776 26804 48 112 2784 756 1884 3789 67 33 0 0 2 2 96216 45756 21616 26964 0 232 1180 416 1535 2823 92 8 0 0 1 2 96216 45596 22284 27588 156 0 1444 0 1471 8843 87 13 0 0 1 2 96344 44196 21392 30276 0 220 3356 440 1437 2290 94 6 0 0 1 2 97092 45148 20336 31524 184 824 2428 1436 1382 2312 68 32 0 0 1 2 97268 45540 20224 32124 260 196 2092 580 1479 2424 91 9 0 0 3 1 97452 45540 19804 32104 0 192 2372 324 1525 2766 92 8 0 0 1 3 97752 44140 18468 35512 0 320 4848 360 1494 2746 70 30 0 0 1 2 98228 45476 17712 35524 0 504 1428 888 1447 2364 90 10 0 0 1 2 98228 44412 18164 35252 0 0 1392 448 1495 2852 91 9 0 0 1 2 99076 45084 17864 35488 4 1052 2452 1532 1497 2424 91 9 0 0 2 2 99624 45364 18336 35812 16 908 1992 1016 1559 2646 65 35 0 0 1 2 100132 45420 17736 36960 4 664 2600 736 1486 2142 83 17 0 0 procs -----------memory---------- ---swap-- -----io---- --system-- ----cpu---- r b swpd free buff cache si so bi bo in cs us sy id wa 1 5 100132 44836 18256 37744 88 0 1392 0 1469 2475 80 5 0 15 1 3 100576 43940 18144 37588 676 488 1076 2252 1452 2241 88 7 0 5 1 4 100612 45284 18372 37088 0 52 836 128 1494 2381 73 27 0 0 1 2 100928 46012 19008 36296 0 380 1272 468 1561 2927 85 15 0 0 1 2 101112 46172 19108 36244 36 212 1468 276 1492 2122 93 7 0 0 1 3 101224 45668 18924 36384 56 120 1544 196 1457 2479 95 5 0 0 0 5 101484 44492 18656 35980 476 300 1408 2208 1455 2372 37 31 0 33 1 3 101484 44044 19184 36280 64 0 888 468 1482 2360 32 5 0 63 2 3 101716 44380 18476 35944 0 236 1312 484 1457 2256 93 7 0 0 1 2 101884 45692 18280 35880 32 216 1096 292 1431 2330 93 7 0 0 1 2 102276 45356 18204 35356 336 444 1208 452 1440 2191 93 7 0 0 1 2 102372 45948 18028 35320 176 96 1092 604 1377 1887 66 29 0 5 1 3 102384 44492 18124 35376 28 52 1784 64 1470 1874 77 4 0 19 2 2 102856 45556 17196 35644 80 568 1644 1640 1507 1774 93 7 0 0 1 3 103108 45164 17704 36132 44 252 1980 268 1632 2248 65 35 0 0 1 3 103228 44428 17352 36532 92 120 1668 128 1585 2236 87 13 0 0 1 3 103452 44092 17596 36440 112 228 1672 1696 1598 2256 92 8 0 0 1 6 103660 45540 16664 35644 1076 216 2536 244 1502 2689 71 29 0 0 1 2 103776 44028 16088 36244 560 128 2044 296 1461 1643 93 7 0 0 1 2 104264 45204 14808 35596 112 616 1652 876 1450 1985 91 9 0 0 1 2 104472 44196 14508 35632 32 496 640 496 1536 1663 90 10 0 0 procs -----------memory---------- ---swap-- -----io---- --system-- ----cpu---- r b swpd free buff cache si so bi bo in cs us sy id wa 2 2 104600 46492 13396 34876 432 200 1664 668 1461 2093 70 30 0 0 1 3 104664 46044 14652 34780 184 104 2608 140 1793 3130 90 10 0 0 1 2 104852 44140 14576 35284 524 244 2352 332 1529 2197 92 8 0 0 1 1 105372 46660 13256 34792 732 612 1304 2372 1544 1842 71 29 0 0 1 2 105372 44924 14568 35152 104 0 1776 0 1654 2364 94 6 0 0 1 2 105540 44476 15504 34696 100 172 1728 880 1698 2911 89 11 0 0 1 3 105520 44460 16144 34244 220 4 1840 92 1617 2390 63 37 0 0 1 11 105828 45300 14668 33528 2260 388 3416 416 1473 1859 74 20 0 6 1 7 106180 45156 13012 33976 788 604 2824 632 1520 1452 48 5 0 46 1 8 106824 45516 12460 33920 1208 776 2760 776 1504 1826 92 8 0 0