sis190 driver
Quoted 2 lines
Message du 29/07/05 00:13
De : "Francois Romieu" <[email protected]>
[...]
Quoted 1 line
Changes from previous version (20050722)
[...]
Quoted 4 lines
o Minor round of mii/phy related changes. May crash.
Testing reports/review/patches are always appreciated.
sis190-120 compiles, loads but does not work (sis190_init_phy() function).
# service network start
Bringing up loopback interface: [ OK ]
Bringing up interface eth0:
Determining IP information for eth0... failed; no link present. Check cable?
[FAILED]#dmesg
sis190 Gigabit Ethernet driver 1.2 loaded.
ACPI: PCI Interrupt 0000:00:04.0[A] -> Link [LNKD] -> GSI 11 (level, low) -> IRQ 11
PCI: Setting latency timer of device 0000:00:04.0 to 64
0000:00:04.0: Read MAC address from APC.
eth0: Unknown PHY transceiver at address 1.
0000:00:04.0: sis190 at ffffc20000004c00 (IRQ: 11), 00:11:2f:e9:42:70
eth0: Enabling Auto-negotiation.
# ethtool eth0
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
Advertised auto-negotiation: Yes
Speed: 100Mb/s
Duplex: Full
Port: MII
PHYAD: 0
Transceiver: internal
Auto-negotiation: on
Current message level: 0x00000037 (55)
Link detected: noI reverted to sis190-110, which works well on my box.
--
Pascal
Pascal CHAPPERON <[email protected]> :
[...]
Quoted 7 lines
sis190-120 compiles, loads but does not work (
sis190_init_phy()function).# service network start Bringing up loopback interface: [ OK ] Bringing up interface eth0: Determining IP information for eth0... failed; no link present. Check cable? [FAILED]
Thanks, your report/dmesg are welcome.
Lars noticed that the link status is not correctly reported and suggested a few changes. Can you check if the version below works better ?
Single file patch:
http://www.zoreil.com/~romieu/sis190/20050730-2.6.13-rc4-sis190-test.patch
Patch-kit:
http://www.zoreil.com/~romieu/sis190/20050730-2.6.13-rc4/patches
Tarball:
http://www.zoreil.com/~romieu/sis190/20050730-2.6.13-rc4.tar.bz2
If it does not pass the network init, can you issue
- ifconfig eth0 blah, blah by hand
- mii-tool -vvv eth0
I'll send the whole serie of patches to netdev/akpm.
Jeff, do you want that I publish it in some git repo as well ?
--
Ueimor