How to completely uninstall a pre-installed package in Yocto #linux #yocto
Hi,
I found out that one of the packages in Yocto is unwanted, and wish to completely uninstall the package.
The question is how to completely uninstall the pre-installed package in Yocto. Thanks
FYI, I am new in building and compiling Yocto image.
Howdy!
Am Mi., 15. Juli 2020 um 07:40 Uhr schrieb Soi, Sheng Leong <[email protected]>:
Quoted 5 lines
The question is how to completely uninstall the pre-installed package in Yocto. Thanks
I found out that one of the packages in Yocto is unwanted, and wish to completely uninstall the package.
In contrast to a general purpose distribution where you have little control over the default set, there is no need to install anything you do not want. So the correct solution is: do not install that package.
Even moreso, removing it later might be impossible if the image doesn't have package management enabled.
Greetz
What I did was. I ran the following:
bitbake <image> -e |grep -v ^# |grep "^DISTRO_FEATURES=\|^IMAGE_FEATURES="
Then used DISTRO_FEATURES_remove in local.conf to remove the unwanted packages.
-=Srijan Nandi
What I did was, ran the following command to see what all gets installed..
bitbake <image> -e |grep -v ^# |grep "^DISTRO_FEATURES=\|^IMAGE_FEATURES="
Then used DISTRO_FEATURES_remove in the local.conf to removed the unnecessary package. Hope this helps.
-=Srijan Nandi
This is what I did. I ran the following:
bitbake <image> -e |grep -v ^# |grep "^DISTRO_FEATURES=\|^IMAGE_FEATURES="
Found out the DISTRO_FEATURES and IMAGE_FEATURES. Thne used DISTRO_FEATURES_remove in the local.conf to remove the features that I do not need. Hope this helps.
-=Srijan Nandi