dpdk_21.02--kni interface does not work properly
Hello,
I've recently migrated from dpdk-18.05 to dpdk-21.02. I built "kni" example according to this tutorial [1 [1]], every thing is fine except that
it has no output packet (no tx). There is a same problem in dpdk-20.11. Have I ignored something? I would be
grateful if anyone could help me.
It may also be helpful to mention that after I change the Interface state to UP, The output of ip link shows that the state of this interface still is DOWN.
outputs:
Quoted 1 line
./BUILD/KNI -L 4-7 -N 4 -- -P -P
0X3--CONFIG="(0,4,6),(1,5,7)"
------------------------------------------------------------------------------------------------------------
EAL: Detected 16 lcore(s)
EAL: Detected 1 NUMA nodes
EAL: Multi-process socket /var/run/dpdk/rte/mp_socket
EAL: Selected IOVA mode 'PA'
EAL: No available hugepages reported in hugepages-1048576kB
EAL: Probing VFIO support...
EAL: VFIO support initialized
EAL: using IOMMU type 1 (Type 1)
EAL: Probe PCI driver: net_i40e (8086:158b) device: 0000:06:00.0 (socket
0)
EAL: Probe PCI driver: net_i40e (8086:158b) device: 0000:06:00.1 (socket
0)
EAL: No legacy callbacks, legacy socket not created
APP: Initialising port 0 ...
APP: Initialising port 1 ...
Checking link status
........done
Port 0 Link up at 10 Gbps FDX Autoneg
Port 1 Link up at 10 Gbps FDX Autoneg
APP: ========================
APP: KNI Running
APP: kill -SIGUSR1 128701
APP: Show KNI Statistics.
APP: kill -SIGUSR2 128701
APP: Zero KNI Statistics.
APP: ========================
APP: Lcore 5 is reading from port 1
APP: Lcore 6 is writing to port 0
APP: Lcore 7 is writing to port 1
APP: Lcore 4 is reading from port 0
APP: Configure network interface of 0 up
KNI: Configure promiscuous mode of 0 to 1
KNI: Configure promiscuous mode of 0 to 0
--------------------------------------------------------------------------------------------------------------
Quoted 3 lines
IFCONFIG VETH0 1.1.2.39/24 UP
TCPDUMP -V -N -I VETH0
------------------------------------------------------------------------------------------------------------
07:22:26.218095 IP (tos 0x0, ttl 64, id 15551, offset 0, flags [DF], proto ICMP (1), length 84)
1.1.2.2 > 1.1.2.39: ICMP echo request, id 229, seq 1, length 64 07:22:27.218093 IP (tos 0x0, ttl 64, id 15619, offset 0, flags [DF], proto ICMP (1), length 84)
1.1.2.2 > 1.1.2.39: ICMP echo request, id 229, seq 2, length 64 07:22:28.242082 IP (tos 0x0, ttl 64, id 15826, offset 0, flags [DF], proto ICMP (1), length 84)
1.1.2.2 > 1.1.2.39: ICMP echo request, id 229, seq 3, length 64 07:22:29.266097 IP (tos 0x0, ttl 64, id 15948, offset 0, flags [DF], proto ICMP (1), length 84)
1.1.2.2 > 1.1.2.39: ICMP echo request, id 229, seq 4, length 64 07:22:30.290083 IP (tos 0x0, ttl 64, id 16060, offset 0, flags [DF], proto ICMP (1), length 84)
1.1.2.2 > 1.1.2.39: ICMP echo request, id 229, seq 5, length 64 07:22:31.314073 IP (tos 0x0, ttl 64, id 16118, offset 0, flags [DF], proto ICMP (1), length 84)
1.1.2.2 > 1.1.2.39: ICMP echo request, id 229, seq 6, length 64 07:22:32.342079 IP (tos 0x0, ttl 64, id 16236, offset 0, flags [DF], proto ICMP (1), length 84)
1.1.2.2 > 1.1.2.39: ICMP echo request, id 229, seq 7, length 64 07:22:33.366074 IP (tos 0x0, ttl 64, id 16332, offset 0, flags [DF], proto ICMP (1), length 84)
1.1.2.2 > 1.1.2.39: ICMP echo request, id 229, seq 8, length 64 07:22:34.390079 IP (tos 0x0, ttl 64, id 16511, offset 0, flags [DF], proto ICMP (1), length 84)
1.1.2.2 > 1.1.2.39: ICMP echo request, id 229, seq 9, length 64
--------------------------------------------------------------------------------------------------------------
Best Regards
Links:
------
[1]
https://doc.dpdk.org/guides-21.02/sample_app_ug/kernel_nic_interface.html
[1]
Links:
------
[1]
https://doc.dpdk.org/guides-20.11/sample_app_ug/kernel_nic_interface.html
Quoted 9 lines · mirzaei.reza
Hello,
I've recently migrated from dpdk-18.05 to dpdk-21.02. I built "kni" example according to this tutorial [1 [1]], every thing is fine except that
it has no output packet (no tx). There is a same problem in dpdk-20.11. Have I ignored something? I would be
grateful if anyone could help me.
Quoted 4 lines
It may also be helpful to mention that after I change the Interface state to UP, The output of
ip linkshows that the state of this interface still is DOWN.
It can be related to the 'carrier' update for the kni interfaces [1].
Can you please check following for your interface '<iface>':
"cat /sys/class/net/<iface>/carrier"
There are a few options,
- insert 'rte_kni.ko' kernel module with "carrier=on" kernel param, to default enable the carrier. "insmod ./build/kernel/linux/kni/rte_kni.ko carrier=on"
- use '-m' argument to 'dpdk-kni' sample app, to reflect actual device carrier status to the kni interface:
./build/examples/dpdk-kni -l0,40-44 -- -m -P -p0x3 --config "(0,40,42),(1,41,43)"
Quoted 91 lines
outputs:
Quoted 1 line
./BUILD/KNI -L 4-7 -N 4 -- -P -P
0X3--CONFIG="(0,4,6),(1,5,7)"------------------------------------------------------------------------------------------------------------
EAL: Detected 16 lcore(s)
EAL: Detected 1 NUMA nodes
EAL: Multi-process socket/var/run/dpdk/rte/mp_socket
EAL: Selected IOVA mode 'PA'
EAL: No available hugepages reported in hugepages-1048576kB
EAL: Probing VFIO support...
EAL: VFIO support initialized
EAL: using IOMMU type 1 (Type 1)
EAL: Probe PCI driver:net_i40e(8086:158b) device: 0000:06:00.0 (socket
0)
EAL: Probe PCI driver:net_i40e(8086:158b) device: 0000:06:00.1 (socket
0)
EAL: No legacy callbacks, legacy socket not created
APP: Initialising port 0 ...
APP: Initialising port 1 ...Checking link status
........done
Port 0 Link up at 10 Gbps FDX Autoneg
Port 1 Link up at 10 Gbps FDX Autoneg
APP: ========================
APP: KNI Running
APP: kill -SIGUSR1 128701
APP: Show KNI Statistics.
APP: kill -SIGUSR2 128701
APP: Zero KNI Statistics.
APP: ========================
APP: Lcore 5 is reading from port 1
APP: Lcore 6 is writing to port 0
APP: Lcore 7 is writing to port 1
APP: Lcore 4 is reading from port 0
APP: Configure network interface of 0 up
KNI: Configure promiscuous mode of 0 to 1
KNI: Configure promiscuous mode of 0 to 0--------------------------------------------------------------------------------------------------------------
Quoted 3 lines
IFCONFIG VETH0 1.1.2.39/24 UP
TCPDUMP -V -N -I VETH0
------------------------------------------------------------------------------------------------------------
07:22:26.218095 IP (tos
0x0, ttl 64, id 15551, offset 0, flags [DF], proto ICMP (1), length 84)
1.1.2.2 > 1.1.2.39: ICMP echo request, id 229, seq 1, length 64 07:22:27.218093 IP (tos0x0, ttl 64, id 15619, offset 0, flags [DF], proto ICMP (1), length 84)
1.1.2.2 > 1.1.2.39: ICMP echo request, id 229, seq 2, length 64 07:22:28.242082 IP (tos0x0, ttl 64, id 15826, offset 0, flags [DF], proto ICMP (1), length 84)
1.1.2.2 > 1.1.2.39: ICMP echo request, id 229, seq 3, length 64 07:22:29.266097 IP (tos0x0, ttl 64, id 15948, offset 0, flags [DF], proto ICMP (1), length 84)
1.1.2.2 > 1.1.2.39: ICMP echo request, id 229, seq 4, length 64 07:22:30.290083 IP (tos0x0, ttl 64, id 16060, offset 0, flags [DF], proto ICMP (1), length 84)
1.1.2.2 > 1.1.2.39: ICMP echo request, id 229, seq 5, length 64 07:22:31.314073 IP (tos0x0, ttl 64, id 16118, offset 0, flags [DF], proto ICMP (1), length 84)
1.1.2.2 > 1.1.2.39: ICMP echo request, id 229, seq 6, length 64 07:22:32.342079 IP (tos0x0, ttl 64, id 16236, offset 0, flags [DF], proto ICMP (1), length 84)
1.1.2.2 > 1.1.2.39: ICMP echo request, id 229, seq 7, length 64 07:22:33.366074 IP (tos0x0, ttl 64, id 16332, offset 0, flags [DF], proto ICMP (1), length 84)
1.1.2.2 > 1.1.2.39: ICMP echo request, id 229, seq 8, length 64 07:22:34.390079 IP (tos0x0, ttl 64, id 16511, offset 0, flags [DF], proto ICMP (1), length 84)
1.1.2.2 > 1.1.2.39: ICMP echo request, id 229, seq 9, length 64--------------------------------------------------------------------------------------------------------------
Best Regards
Links:
------
[1]
https://doc.dpdk.org/guides-21.02/sample_app_ug/kernel_nic_interface.html
[1]Links:
------
[1]
https://doc.dpdk.org/guides-20.11/sample_app_ug/kernel_nic_interface.html