i915: slow acpi_lid_open() causes flickering - V2
Subsystems (2)
PATCH 1/1 i915: slow acpi_lid_open() causes flickering - V2
acpi_lid_open() could take up to 10ms on my computer. Some component is calling the drm GETCONNECTOR ioctl many times in a row. This results in flickering (for example, when starting a video). Fix it by assuming an always connected lid status.
Signed-off-by Thomas Meyer <[email protected]>
--- drivers/gpu/drm/i915/intel_lvds.c | 9 ++++++++- 1 files changed, 8 insertions(+), 1 deletions(-)
drivers/gpu/drm/i915/intel_lvds.c +8 -1
@@ -623,6 +623,13 @@ static const struct dmi_system_id bad_lid_status[] = { }, }, { + .ident = "Aspire 1810T", + .matches = { +DMI_MATCH (DMI_SYS_VENDOR ,"Acer" ), + DMI_MATCH(DMI_PRODUCT_NAME, "Aspire 1810T"), + }, + }, + { .ident ="PC-81005" , .matches = { DMI_MATCH(DMI_SYS_VENDOR, "MALATA"),
@@ -643,7 +650,7 @@ static enum drm_connector_status intel_lvds_detect(struct drm_connector *connect {enum drm_connector_status status = connector_status_connected; -if (!acpi_lid_open () && !dmi_check_system (bad_lid_status)) +if (!dmi_check_system (bad_lid_status) && !acpi_lid_open ()) status = connector_status_disconnected;return status;
Signature · 1 line
1.6.6
Eric Anholt
AppliedQuoted 4 lines · Thomas Meyer
acpi_lid_open()could take up to 10ms on my computer. Some component is calling the drm GETCONNECTOR ioctl many times in a row. This results in flickering (for example, when starting a video). Fix it by assuming an always connected lid status.
Applied. Thanks!