TQM5200: Call usb_cpu_init() during board init

usb_cpu_init() configures GPS USB pins, clocks, etc. and is required for proper operation of kernel USB subsystem. This setup was previously done in the kernel by the fixup code which is being removed, thus low level init must be done by U-boot now.

---

 board/tqm5200/tqm5200.c |   10 ++++++++--
 1 files changed, 8 insertions(+), 2 deletions(-)

index 29d6f00..9e24578 100644
@@ -441,15 +441,21 @@ ulong post_word_load (void)
 }
 #endif	/* CONFIG_POST || CONFIG_LOGBUFFER*/
 
-#ifdef CONFIG_PS2MULT
 #ifdef CONFIG_BOARD_EARLY_INIT_R
 int board_early_init_r (void)
 {
+#ifdef CONFIG_PS2MULT
 	ps2mult_early_init();
+#endif /* CONFIG_PS2MULT */
+
+#if defined(CONFIG_USB_OHCI_NEW) && defined(CFG_USB_OHCI_CPU_INIT)
+	/* Low level USB init, required for proper kernel operation */
+	usb_cpu_init();
+#endif
+
 	return (0);
 }
 #endif
-#endif /* CONFIG_PS2MULT */
 
 #ifdef CONFIG_FO300
 int silent_boot (void)

Thanks, added to USB custodian repo.

Best regards

Markus Klotzbuecher

--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: office at denx.de

Applied, thanks.

Best regards,

Wolfgang Denk

DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
A good marriage would be between a blind wife and deaf husband.
                                               -- Michel de Montaigne