No ACPI control over fan/termal zone on Toshiba Tecra M3, kernel 2.6.17
Hello,
I'll try to be brief, but up to the point.
Problem: I got Toshiba Tecra M3 (notebook). ACPI support is good, but termal zone lacks tripping points (this I could probably live with) and fan lacks any control/readings at all (this is annoying since fan is always on). Fan speed is changing as CPU load/termal zone temp is changing, but it never completely stops, even if termal zone temp is as low as 41C.
Desired solution: got some degree of control over fan adn/or termal zone and be able to make fan silent at least 50% of the time.
What I already did:
I read archives of this list and googled for "toshiba fan", "toshiba dsdt acpi", etc. I haven't found any useful advice, but I got a lot of hints. I disasembled my dsdt and looked for "_TZ", "PFN" and "PNP0C0B". I found only "_TZ", and only in small piece of code:
Scope (\_TZ)
{
ThermalZone (THRM)
{
Method (_TMP, 0, NotSerialized)
{
If (LLessEqual (\_SB.MEM.TMP1, 0x0B4C))
{
Store (0x0B4C, \_SB.MEM.AST1)
Return (0x0B4C)
}
Else
{
Store (\_SB.MEM.TMP1, \_SB.MEM.AST1)
Return (\_SB.MEM.TMP1)
}
}
Method (_CRT, 0, NotSerialized)
{
Return (\_SB.MEM.CRT1)
}
}
}It seems that there are no references to fan(s) in DSDT at all. Does this mean that I have no hope and should live with things as they are?
Attached are: dsdt, dsdt disassembly, dmidecode and acpidump outputs. Hope that this is not too off-topic.
Signature · 3 lines
-- Dmitry Astapov //ADEpt GPG Key/fprint: F5D7639D/CA36E6C4 815D434D 04982B08 78674860 F5D7639D