Skip to contentSkip to conversation

How to get tx rate in ath10k?

DISCUSSION Ben Greear 2 participants 3 messages Mar 25, 2014 Qualcomm Atheros ATH10K wireless driver

lore
Share & tools
lore

Ben Greear

author
#0 lore raw

With Janusz's changes, rx rate and rx-signal appear to be reported correctly.

But, tx-rate is not reported.

Anyone have any suggestions for what needs doing to get tx rate properly reported?

Thanks,
Ben

Signature · 8 lines
Ben Greear <[email protected]>
Candela Technologies Inc  http://www.candelatech.com


_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k
#1 lore raw
Quoted 7 lines · Ben Greear

With Janusz's changes, rx rate and rx-signal appear to be reported correctly.

But, tx-rate is not reported.

Anyone have any suggestions for what needs doing to get tx rate properly reported?

Firmware does not provide this information to the host currently, so this will need firmware changes.

Signature · 6 lines
Kalle Valo

_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k
author
#2 lore raw
Quoted 5 lines · Kalle Valo
Quoted 3 lines · Ben Greear

With Janusz's changes, rx rate and rx-signal appear to be reported correctly.

Quoted 7 lines
Quoted 4 lines

But, tx-rate is not reported.

Anyone have any suggestions for what needs doing to get tx rate properly reported?

Firmware does not provide this information to the host currently, so this will need firmware changes.

Ok, that was what I suspected. I'll work on adding it to my firmware...

Thanks,
Ben

Signature · 8 lines
Ben Greear <[email protected]>
Candela Technologies Inc  http://www.candelatech.com


_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k