Skip to contentSkip to conversation

pcmcia-issues with 2.2.18 & 2.4.0

DISCUSSION Stig Brautaset 2 participants 2 messages Feb 13, 2001

lore
Share & tools
lore
#0 lore raw

I am no kernel hacker, but I would like to file a bug-report none the less. Please CC me with follow-ups (if any ;-) since I am not subscribing to the mailing list.

I have a Xircom Combo CardBus (32 bit) 10/100 Ethernet Card + 56k Modem (didn't try the modem part) that I have not been able to run under 2.2.18 or 2.4.0. The weird part is that everything seems to load fine, and I am able to configure the card with an ip-address and everything. Only sad part is that I can not reach out to the world. I just get connection time-outs when trying to acces the 'net.

The card runs fine under 2.2.17, but not with pcmcia-cs package version later than 3.1.20 (I do realize that this probably have little to do with the kernel).

BTW, The driver used by the card is tulip_cb, and the machine it runs on is a Dell Latitude CPx H500GT.

Regards, Stig
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://vger.kernel.org/lkml/

#1 lore raw
Quoted 9 lines · Stig Brautaset

I have a Xircom Combo CardBus (32 bit) 10/100 Ethernet Card + 56k Modem (didn't try the modem part) that I have not been able to run under 2.2.18 or 2.4.0. The weird part is that everything seems to load fine, and I am able to configure the card with an ip-address and everything. Only sad part is that I can not reach out to the world. I just get connection time-outs when trying to acces the 'net.

BTW, The driver used by the card is tulip_cb, and the machine it runs on is a Dell Latitude CPx H500GT.

I use:
alias eth0 xircom_tulip_cb

and when this happens -90% if times when I boot and 100% of time when I awake after a sleep- I just do the following:

ifconfig eth0 -promisc

and it works again.

Pau