Skip to contentSkip to conversation

Rust ENC28J60 ethernet driver working on Raspberry Pi

DISCUSSION Ryo Munakata 2 participants 2 messages Apr 29, 2023 – May 12, 2023 Rust

lore
Share & tools
lore
#0 lore raw

Hi all,

I've written an ethernet driver for ENC28J60, a stand-alone ethernet controller with a SPI interface, in Rust. It works fine on Raspberry Pi 4B with Raspbian AArch64.
You can connect to the internet and play some videos on YouTube with it (10BASE-T though).
I hope it will be an example of real-world drivers in Rust.

* ENC28J60 ethernet driver in Rust
enc28j60rs: https://github.com/pfpacket/enc28j60rs
impl Sync/Send, mostly because of raw pointers, and the initialization of workqueue::Work and sync::Spinlock require a tiny bit of "unsafe" code, but otherwise no unsafe code used.

* The forked kernel with Rust support for SPI and netdev
https://github.com/pfpacket/linux-rpi-rust/tree/rust-netdev
Forked from the Raspberry Pi tree and merged Rust-for-Linux rust branch into it. (BTW are there any easier way to get Rust-for-Linux work on Raspberry Pi? If so please let me know.) Then I added the SPI support referencing rust/kernel/platform.rs and netdev support. The netdev support is based on the following GitHub PR from Fujita-san:
https://github.com/Rust-for-Linux/linux/pull/908

Regards,
Ryo Munakata

#1 lore raw
Quoted 15 lines · Ryo Munakata

Hi all,

I've written an ethernet driver for ENC28J60, a stand-alone ethernet controller with a SPI interface, in Rust.
It works fine on Raspberry Pi 4B with Raspbian AArch64.
You can connect to the internet and play some videos on YouTube with it (10BASE-T though).
I hope it will be an example of real-world drivers in Rust.

* ENC28J60 ethernet driver in Rust
enc28j60rs: https://github.com/pfpacket/enc28j60rs
impl Sync/Send, mostly because of raw pointers, and the initialization of workqueue::Work and sync::Spinlock
require a tiny bit of "unsafe" code, but otherwise no unsafe code used.

Quoted 10 lines

* The forked kernel with Rust support for SPI and netdev
https://github.com/pfpacket/linux-rpi-rust/tree/rust-netdev
Forked from the Raspberry Pi tree and merged Rust-for-Linux rust branch into it.
(BTW are there any easier way to get Rust-for-Linux work on Raspberry Pi? If so please let me know.)
Then I added the SPI support referencing rust/kernel/platform.rs and netdev support.
The netdev support is based on the following GitHub PR from Fujita-san:
https://github.com/Rust-for-Linux/linux/pull/908

This is cool, thanks! I will check it out at some point.

Best regards
Andreas Hindborg