Skip to contentSkip to conversation

Ethernet bridging on MPC8248

DISCUSSION Ole Andreas Torvmark 2 participants 2 messages May 2, 2005 – May 3, 2005

lore
Share & tools
lore
#0 lore raw

Hi !

I've a custom board with a MPC8248 with two LXT972 10/100MBit ethernet phys.

The board is running 2.6.9-rc1, and I'm using the FCC ENET Version 0.3 driver with some modifications.

My question is :

I've tried to get ethernet briding between the two ethernet ports to work.

I've set up the following :

ifconfig eth0 0.0.0.0
ifconfig eth1 0.0.0.0
brctl addbr br0
brctl addif br0 eth0
brctl addif br0 eth1
ifconfig br0 192.168.0.222 netmask 255.255.255.0

If I connect a machine to port 0 (eth0) then I can ping the bridge from that machine,
If I connect a machine to port 1 (eth1) I cannot ping the bridge.
If I connect machines to both ports, I cannot ping one machine from the other, the only thing i can successfully ping is from port 0 to bridge and from bridge to port 0

Is this a known problem with the FCC ENET driver or does it support bridging fully ?

best regards

Ole Andreas Torvmark
R & D Engineer
Radionor Communications AS

#1 lore raw
Quoted 10 lines · Ole Andreas Torvmark

ifconfig eth0 0.0.0.0
ifconfig eth1 0.0.0.0
brctl addbr br0
brctl addif br0 eth0
brctl addif br0 eth1
ifconfig br0 192.168.0.222 netmask 255.255.255.0

If I connect a machine to port 0 (eth0) then I can ping the bridge from that machine,

Quoted 7 lines

If I connect a machine to port 1 (eth1) I cannot ping the bridge. If I connect machines to both ports, I cannot ping one machine from the other, the only thing i can successfully ping is from port 0 to bridge and from bridge to port 0

Is this a known problem with the FCC ENET driver or does it support bridging fully ?

Have you made sure that eth0 and eth1 are 'up'? eg) ifconfig eth0 up. I'm not sure, but br0 may need to be up as well.