mt76: mt7603: use the correct hweight8() function
Subsystems (2)
Felix Fietkau
maintainerPATCH 1/1 mt76: mt7603: use the correct hweight8() function
__sw_hweight8() is only defined if CONFIG_GENERIC_HWEIGHT is enabled. The function that works on all architectures is hweight8().
--- drivers/net/wireless/mediatek/mt76/mt7603/beacon.c | 3 +-- drivers/net/wireless/mediatek/mt76/mt7603/init.c | 2 +- drivers/net/wireless/mediatek/mt76/mt7603/mcu.c | 2 +- 3 files changed, 3 insertions(+), 4 deletions(-)
drivers/net/wireless/mediatek/mt76/mt7603/beacon.c +1 -2
@@ -135,8 +135,7 @@ void mt7603_pre_tbtt_tasklet(unsigned long arg) out:mt76_queue_tx_cleanup (dev,MT_TXQ_BEACON , false); -if (dev->mt76.q_tx[MT_TXQ_BEACON ].queued > -__sw_hweight8 (dev->beacon_mask)) +if (dev->mt76.q_tx[MT_TXQ_BEACON ].queued >hweight8 (dev->beacon_mask)) dev->beacon_check++; }
drivers/net/wireless/mediatek/mt76/mt7603/init.c +1 -1
@@ -112,7 +112,7 @@ static void mt7603_phy_init(struct mt7603_dev *dev) {int rx_chains = dev->mt76.antenna_mask; -int tx_chains =__sw_hweight8 (rx_chains) -1 ; +int tx_chains =hweight8 (rx_chains) -1 ; mt76_rmw(dev, MT_WF_RMAC_RMCR, (MT_WF_RMAC_RMCR_SMPS_MODE |
drivers/net/wireless/mediatek/mt76/mt7603/mcu.c +1 -1
@@ -433,7 +433,7 @@ int mt7603_mcu_set_channel(struct mt7603_dev *dev) {struct cfg80211_chan_def *chandef = &dev->mt76.chandef;struct ieee80211_hw *hw =mt76_hw (dev); -int n_chains =__sw_hweight8 (dev->mt76.antenna_mask); +int n_chains =hweight8 (dev->mt76.antenna_mask);struct {u8 control_chan;u8 center_chan;
Signature · 1 line
2.17.0
Quoted 4 lines · Felix Fietkau
__sw_hweight8()is only defined ifCONFIG_GENERIC_HWEIGHTis enabled. The function that works on all architectures ishweight8().Signed-off-by Felix Fietkau <[email protected]>
This should go to 5.1, right?
Signature · 1 line
Kalle Valo
Felix Fietkau
maintainerQuoted 8 lines · Kalle Valo
Quoted 4 lines · Felix Fietkau
__sw_hweight8()is only defined ifCONFIG_GENERIC_HWEIGHTis enabled. The function that works on all architectures ishweight8().Signed-off-by Felix Fietkau <[email protected]>This should go to 5.1, right?
Yes.
- Felix
Quoted 4 lines · Felix Fietkau
__sw_hweight8()is only defined ifCONFIG_GENERIC_HWEIGHTis enabled. The function that works on all architectures ishweight8().Signed-off-by Felix Fietkau <[email protected]>
Patch applied to wireless-drivers.git, thanks.
f2a00a821aac mt76: mt7603: use the correct hweight8() function
Signature · 3 lines
https://patchwork.kernel.org/patch/10847433/ https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches