mtd: rawnand: qcom: Add initial support for qspi nand
Quoted 23 lines · Boris Brezillon
Hello,
Quoted 11 lines · On Sat, 10 Oct 2020 11:01:39 +0530 Md Sadre Alam <[email protected]> wrote:
This change will add initial support for qspi (serial nand).
QPIC Version v.2.0 onwards supports serial nand as well so this change will initialize all required register to enable qspi (serial nand).
This change is supporting very basic functionality of qspi nand flash.
1. Reset device (Reset QSPI NAND device).
2. Device detection (Read id QSPI NAND device).
Unfortunately, that's not going to work in the long term. You're basically hacking the raw NAND framework to make SPI NANDs fit. I do understand the rationale behind this decision (re-using the code for ECC and probably other things), but that's not going to work. So I'd recommend doing the following instead:
Quoted 6 lines
1/ implement a SPI-mem controller driver
2/ implement an ECC engine driver so the ECC logic can be shared
between the SPI controller and raw NAND controller drivers
3/ convert the raw NAND driver to theexec_op()interface (none of
this hack would have been possible if the driver was using the new API)
Sorry for late reply. I think I mixup the serial nand support and QPIC_V2.0 support. Only patches [2/5] mtd: rawnand: qcom: Add initial support for qspi nand and [5/5] mtd: rawnand: qcom: Add support for serial training. are for serial nand. Other patches [3/5] mtd: rawnand: qcom: Read QPIC version &
[4/5] mtd: rawnand: qcom: Enable support for erase,read & write for serial nand. are to support QPIC_V2.0. In QPIC_V2.0 onwards some additional registers and features got added. QPIC_NAND_READ_LOCATION_LAST_CW_n register got added to read last code word. Page scope read & multi page read feature got added to read single and multiple pages. QPIC_NAND_AUTO_STATUS_EN register got added to read status in page scope read & multi page read etc.
I will take out QPIC_V2.0 support patches and will push it separately.
For serial nand support few lines of codes are there around 50 lines
to initalize QPIC serial block and serial training code. So can I put this this as a separate file inside drivers/mtd/nand/raw/qpic_serial_nand.c. Would it be ok ? Because there is no dedicated spi controller for serial nand. QPIC controller having one serial interface block to deal with serial nand device.
Quoted 4 lines
Regards,
Boris