Skip to contentSkip to conversation

ETHERNET TX problem with ADS860 (MPC850), Using SCC ETHERNET device

U-Boot-Users FLAMENT David 2 participants 2 messages Mar 30, 2005 – Mar 31, 2005

lore
Share & tools
lore
#0 lore raw

Hello,
I try to use a ADS860 with a MPC850.
I compile u-boot, dowload in flash and reset.
When reset, I see at prompt this :

Board: ADS rev PILOT
DRAM: 4M 60ns DRAM: 4 MB
FLASH: 2 MB
In: serial
Out: serial
Err: serial
Net: SCC ETHERNET
PCMCIA:No card present
Hit any key to stop autoboot: 0
## Booting image at fe080000 ...
Bad Magic Number

After I set configuration of IP service :

=>setenv ethaddr 00:01:02:2A:3B:4A;setenv serverip 172.17.21.30;setenv ipaddr 172.17.21.33;setenv gatewayip 172.17.0.1;setenv netmask 255.255.0.0;

And I try to ping to my host :

=>ping 172.17.21.30
Using SCC ETHERNET device
TX timeout
TX not ready
TX timeout
ping failed; host 172.17.21.30 is not alive
=>

Cable is tested, and I'm sure cable plugged into the right port because the led of ETH-0 and LD10 is on and indicate good link integrity on th TP port. When ping, Ethernet TX indicator blinks (LD6) is not active but Ethernet RX indicator blinks is active when there are activity on networks ! I don't understand this !

If you are a idea ! please !
Thank you for your answer !

David Flament

--------------------------------
Flament David
d.flament at sofrel.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.denx.de/pipermail/u-boot/attachments/20050330/0b4f378d/attachment.htm

#1 lore raw
Quoted 4 lines · In message <892C3EC180087B4498C69413FCCBB73201316469@sof_msg> you wrote:

I try to use a ADS860 with a MPC850.
I compile u-boot, dowload in flash and reset.
When reset, I see at prompt this :

How did you configure U-Boot? Only the "FADS850SAR" configuration supports a MPC850 processor, but you write "ADS860" which does not fit.

Quoted 1 line

Board: ADS rev PILOT

May I recommend to use this as a door stop and get some working hardware instead?

Quoted 9 lines

And I try to ping to my host :

=>ping 172.17.21.30
Using SCC ETHERNET device
TX timeout
TX not ready
TX timeout
ping failed; host 172.17.21.30 is not alive
=>

This is most probably a misconfiguration of U-Boot; the MPC850 and MPC860 use different port pins. I guess you mixed those up.

Best regards,

Wolfgang Denk

Signature · 5 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
He'd heard her use that sweet, innocent  tone  of  voice  before.  It
meant that, pretty soon, there was going to be trouble.
                                        - Terry Pratchett, _Truckers_