Skip to contentSkip to conversation

mtd: rawnand: Cure MICRON NAND partial erase

RFC PATCH In review Wojtaszczyk, Piotr 2 participants 3 messages Nov 30, 2018 – Dec 2, 2018 1 message not in the archive Memory technology devices (MTD)

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw

RFC PATCH 1/1 mtd: rawnand: Cure MICRON NAND partial erase

On which micron part are you seeing the problem. I'm using MT29F4G16A and see similar issue. Data sheet says that erase takes from 0.7ms up to 3ms don't know if Micron tunes the delay per part or per block. Maybe on some blocks it's not enough.

#2 lore raw
Quoted 4 lines · Piotr

On which micron part are you seeing the problem. I'm using MT29F4G16A and see similar issue. Data sheet says that erase takes from 0.7ms up to 3ms don't know if Micron tunes the delay per part or per block. Maybe on some blocks it's not enough.

MT29F8G08. But I doubt, that it's a delay issue. My current findings tell me it's related to the amount of data (probably 0 bits) in a block. But that's a pure conclusion from observation and not scientific analysis.

Thanks,

Thomas

#3 lore raw

RFC PATCH 1/1 mtd: rawnand: Cure MICRON NAND partial erase issue

In reply to a message not in the archive

On which micron part are you seeing the problem. I'm using MT29F4G16A and see similar issue. Data sheet says that erase takes from 0.7ms up to 3ms don't know if Micron tunes the delay per part or per block. Maybe on some blocks it's not enough.