Skip to contentSkip to conversation

net: phy: check PMAPMD link status only in genphy_c45_read_link

PATCH Applied Heiner Kallweit 2 participants 2 messages Feb 22, 2019 – Feb 25, 2019

Subsystems (3)
lore
Share & tools
lore

Heiner Kallweit

author maintainer
#0 lore raw

PATCH 1/1 net: phy: check PMAPMD link status only in genphy_c45_read_link

The current code reports a link as up if all devices (except a few blacklisted ones) report the link as up. This breaks Aquantia AQCS109 for lower speeds because on this PHY the PCS link status reflects a 10G link only. For Marvell there's a similar issue, therefore PHYXS device isn't checked.

There may be more PHYs where depending on the mode the link status of only selected devices is relevant.

For now it seems to be sufficient to check the link status of the PMAPMD device only. Leave the loop in the code to be prepared in case we have to add functionality to check more than one device, depending on the mode.

Successfully tested on a board with an AQCS109.

---
 drivers/net/phy/phy-c45.c | 9 +--------
 1 file changed, 1 insertion(+), 8 deletions(-)
drivers/net/phy/phy-c45.c +1 -8
index d80797e8d..ce5fa5346 100644
@@ -215,17 +215,10 @@ EXPORT_SYMBOL_GPL(genphy_c45_aneg_done);
  */
 int genphy_c45_read_link(struct phy_device *phydev)
 {
-	u32 mmd_mask = phydev->c45_ids.devices_in_package;
+	u32 mmd_mask = MDIO_DEVS_PMAPMD;
 	int val, devad;
 	bool link = true;
 
-	/* The vendor devads and C22EXT do not report link status. Avoid the
-	 * PHYXS instance as its status may depend on the MAC being
-	 * appropriately configured for the negotiated speed.
-	 */
-	mmd_mask &= ~(MDIO_DEVS_VEND1 | MDIO_DEVS_VEND2 | MDIO_DEVS_C22EXT |
-		      MDIO_DEVS_PHYXS);
-
 	while (mmd_mask && link) {
 		devad = __ffs(mmd_mask);
 		mmd_mask &= ~BIT(devad);
Signature · 1 line
2.20.1
maintainer Applied
#1 lore raw

From: Heiner Kallweit <[email protected]>
Date: Fri, 22 Feb 2019 22:59:38 +0100

Quoted 9 lines

The current code reports a link as up if all devices (except a few blacklisted ones) report the link as up. This breaks Aquantia AQCS109 for lower speeds because on this PHY the PCS link status reflects a 10G link only. For Marvell there's a similar issue, therefore PHYXS device isn't checked.

There may be more PHYs where depending on the mode the link status of only selected devices is relevant.

Quoted 8 lines

For now it seems to be sufficient to check the link status of the PMAPMD device only. Leave the loop in the code to be prepared in case we have to add functionality to check more than one device, depending on the mode.

Successfully tested on a board with an AQCS109.

Applied.