2.6.8-rc4-mm1

Folks,

2.6.8-rc4-mm1 panics when booting (aic7xxx) with lots of SCSI ABORT and sens code errors.
IDE ports give also failed probe messages.

This is on AMD/nForce2 based system under Slackware 10.0 with 2.6.8-rc4-mm1 kernel compiled using GCC 3.3.4. Last kernel that worked was 2.6.8-rc3-mm1.

The 2.6.8-rc3-mm2 flag pci=routeirq which Andrew suggested works and boots this kernel.

Below is the full dmesg/lspci output.

Thanks,

Paul

FreeBSD the Power to Serve!

On Tue, 10 Aug 2004 23:33:30 -0400 Diffie wrote:

| Folks,
| 
| 2.6.8-rc4-mm1 panics when booting (aic7xxx) with lots of SCSI ABORT
| and sens code errors.
| IDE ports give also failed probe messages.
| 
| This is on AMD/nForce2 based system under Slackware 10.0 with
| 2.6.8-rc4-mm1 kernel compiled using GCC 3.3.4. Last kernel that worked
| was 2.6.8-rc3-mm1.
| 
| The 2.6.8-rc3-mm2 flag pci=routeirq which Andrew suggested works and
| boots this kernel.
| 
| Below is the full dmesg/lspci output.

Where are the aic7xxx panics?

Please use your kernel boot log message file(s) or maybe 'dmesg -s100000' to get the complete message log.

--
~Randy

If you could capture the output of the failed kernel, that would be helpful. I know that's a pain unless you're using a serial console. Thanks!

Bjorn

Hi Bjorn,

Yes i have taken pictures which you should get in the previous email...sorry but my serial console does not seem to work on the other (BSD) box thus i can't capture the raw output.

Thanks,

Paul

FreeBSD the Power to Serve!