U-boot - vxWorks booting problems

Hi all!

I begin use U-Boot at my custom board based on TQM823L module. It works fine.
But I have problem with vxWorks image to boot it.

Briefly. I compile vxWorks ram-based ELF image, make .bdx file from it and download BDX throught BDM using visionClick\visionICE.
When I says "GO 100000" it works fine!
After it I make binary image (using ElfToBin utility), make image from it using MKIMAGE utility from U_Boot, upload it to my target using u-boot serial interface, copy to flash - all ok.

When I says "bootm 40040000". Image start to load ok, but after message "Starting vxWorks at 0x100000" target crashed.

I try to make
cp.b 40040040 (where actually image w\o header placed) 100000 $filesize its copied OK
But "go 100000" cause crash again.

I try set brakepoint at address 0x100000 and make step-by-step tracing. And wondering - code at 100000 after copy from flash looks different then I simple download BDX file through BDM before!

I think something wrong with vxWorks binary image after ElfToBin.

Please give me advices and suggestions about possible resolving my problem!

Den.

_________________________________________________________________
The new MSN 8: smart spam protection and 2 months FREE*
http://join.msn.com/?page=features/junkmail

Hi Den,
have you tried to make an image directly from the elf file (using mkimage). I use u-boot to boot a QNX OS which is also contained in an elf image, and I use mkimage on the elf file, then I use bootm on this image and it works fine.

Hoping this helps.

Best regards