Skip to contentSkip to conversation

"Unable to mount root fs on unknown-block(0,0)"

DISCUSSION Ripin Natani 2 participants 2 messages Aug 20, 2003 – Aug 21, 2003 SELinux security module

lore
Share & tools
lore
#0 lore raw

Yes I am booting with an initrd. Basically I do a 'make install' after make 'make modules_install'. The steps that I perform:
make mrproper
make menuconfig
make clean
make bzImage
make modules
make modules_install
make install
I also updated the mkinitrd (i have the 3.4.42 version). Does that have the patch ? Btw I did not find any documentation in linux2.6/README about the patch for the mkinitrd script. ( I hope i looked at the right README !!! ). The system is still giving the same error !
Also I am resending the .config file.
Thanks,
-Ripin

Quoted 9 lines

Are you boot it with an initrd? Did you patch your mkinitrd script per the README so that the initial policy load will occur from the initrd?

The root=LABEL=/ should work fine as long as you are using an initrd (which you should be using, to perform the initial policy load, unless using the old 2.4-based SELinux). If you weren't using an initrd, you would need to specify the actual root device, e.g. root=/dev/hda2 or whatever is appropriate for your system.

Quoted 4 lines

--
Stephen Smalley <[email protected]>
National Security Agency

_________________________________________________________________
<b>Get MSN 8</b> and enjoy automatic e-mail virus protection. http://join.msn.com/?page=features/virus

#1 lore raw
Quoted 1 line · Ripin Natani

Also I am resending the .config file.

Once again the .config file has SE Linux turned off!

Enable the following items in your kernel configuration to turn on SE Linux. But first I recommend that you get a 2.6.0 kernel working without SE Linux, and as I suggested before this list probably isn't the best place to get advice on general kernel configuration issues.

CONFIG_EXT2_FS_SECURITY=y
CONFIG_EXT3_FS_SECURITY=y
CONFIG_SECURITY=y
CONFIG_SECURITY_NETWORK=y
CONFIG_SECURITY_CAPABILITIES=y
CONFIG_SECURITY_SELINUX=y
CONFIG_SECURITY_SELINUX_DEVELOP=y

Signature · 10 lines
http://www.coker.com.au/selinux/   My NSA Security Enhanced Linux packages
http://www.coker.com.au/bonnie++/  Bonnie++ hard drive benchmark
http://www.coker.com.au/postal/    Postal SMTP/POP benchmark
http://www.coker.com.au/~russell/  My home page


--
This message was distributed to subscribers of the selinux mailing list.
If you no longer wish to subscribe, send mail to [email protected] with
the words "unsubscribe selinux" without quotes as the message.