2.4 kernels - "attempt to access beyond end of device"
Quoted 11 lines · Michal Jaegermann
Quoted 7 lines
Quoted 2 lines
I have more checks to make before I will be fully satisfied but this looks like it.
...
Quoted 1 line
System Performance Setting [Optimal, Normal]
...
Try BIOS 1006. AFAIK 1005D changed some VIA values for 'optimal'.
Is that important here? IDE drives in question were not connected to on-board controller but the Promise one. Results seem to indicate that this 'optimal' was important here anyway.
VIA host-bridge, not VIA-IDE... It is important even if you use Promise only - look back through archives, there must be something really wrong with this motherboard.
Quoted 6 lines
Quoted 2 lines
And 1006 contains newer Promise BIOS - but I did not notice any difference:
Windows98 still do not boot if I connect harddisk to/dev/hdh:-(There is at this moment Windows98 installation on
/dev/hde1and it boots
so far. It got installed and it was booting regardless with these
"other" BIOS seetings.
Connect UDMA2 CDROM to hda and UDMA2 IDE to hdg. And then look how Win98 lockup after they print 'Starting Win98...'. But that's offtopic for linux-kernel.
Best regards,
Petr Vandrovec [email protected]
Quoted 9 lines · Petr Vandrovec
Quoted 8 lines · Michal Jaegermann
Quoted 7 lines
Quoted 2 lines
I have more checks to make before I will be fully satisfied but this looks like it.
...
Quoted 1 line
System Performance Setting [Optimal, Normal]
...
Try BIOS 1006. AFAIK 1005D changed some VIA values for 'optimal'.
Quoted 7 lines
Quoted 3 lines
Is that important here? IDE drives in question were not connected to on-board controller but the Promise one. Results seem to indicate that this 'optimal' was important here anyway.
VIA host-bridge, not VIA-IDE... It is important even if you use Promise only - look back through archives, there must be something really wrong with this motherboard.
I'm beginning to believe it may be BIOS revision related. I haven't tried the Promise controller since I don't have an ATA-100 drive, but I don't seem to have any of the data corruption or other problems that people have mentioned. I guess I'll hold off updating the BIOS for now though. I bought the motherboard not two weeks ago, together with a Athlon 900MHz processor and it has BIOS version 1004D. I have seen problems even with Windows using the 1005D version though. My shop has been selling a LOT of this board; the problems we've seen come back seem to be specifically related to 1005D. Reflashing to 1004D has cured any problems I've seen. I've not seen any new hardware come through from the factory with 1006 though.