query regarding 'map_user_kiobuf'
I am using linux kernel version 2.4.2 on Intel PC.
I have been trying my luck for over a week regarding usage of 'map_user_kiobuf' for doing a DMA into a memory area that belongs to user space.
Actually my requirement is that I want to do DMA into a user space memory area. What I have done through suggestions is that allocate memory in user space. I pass user space buffer address to a kernel module. Inside the kernel module, I use 'map_user_kiobuf' passing user space buffer address to it.
After using the 'map_user_kiobuf', I observed the followiing:
1. 'kiobuf->maplist[0]->virtual' contains a different virtual address than the user space buffer address
2. But these two addresses are mapped as when i write something using the address 'kiobuf->maplist[0]->virtual' inside the kernel, I see the same data in the user space buffer in my application.
3. I use the 'virt_to_phys' operation to the virtual address 'kiobuf->maplist[0]->virtual' to get the physical address.
4. I use this physical address for DMA operations.
Now, using this information I do a DMA from card to system memory. What I have noticed is that DMA happens somewhere else in the system memory. I am not able to execute most of the commands (ls, chmod, cat, clear etc) after my user program exits.
Am I doing the steps 3 and 4 above right?
Regards,
Daljeet.
Quoted 11 lines · [email protected] said:
After using the '
map_user_kiobuf', I observed the followiing:1. 'kiobuf->maplist[0]->virtual' contains a different virtual address than the user space buffer address
2. But these two addresses are mapped as when i write something using the address 'kiobuf->maplist[0]->virtual' inside the kernel, I see the same data in the user space buffer in my application.
3. I use the 'virt_to_phys' operation to the virtual address 'kiobuf->maplist[0]->virtual' to get the physical address.
4. I use this physical address for DMA operations.
Quoted 6 lines
Now, using this information I do a DMA from card to system memory. What I have noticed is that DMA happens somewhere else in the system memory. I am not able to execute most of the commands (ls, chmod, cat, clear etc) after my user program exits.
Am I doing the steps 3 and 4 above right?
After calling map_user_kiobuf(), I believe you should be locking the pages in memory by calling lock_kiovec(). Otherwise, nothing prevents them from being paged out again.
Also, the pages may be in high memory and not directly accessible. You should use kmap() before touching them from the kernel rather than just using page->virtual, and obviously kunmap() afterwards.
The PCI DMA interface is more complex than simply using virt_to_phys() too, if you want to deal correctly with the highmem case. I'm sure others will give you the details or pointers to the documentation.
--
dwmw2