Skip to contentSkip to conversation

NETDEV WATCHDOG timeout

DISCUSSION Joseph L. Hill 2 participants 2 messages Feb 4, 2002

lore
Share & tools
lore
#0 lore raw

Greetings,

I have 2.4.7-10smp (RedHat 7.2 install) running on a dell on a dell 2550, the systems runs a mysql/apache applicaton (blackboard). Several times a day, as the load increases I get the following error:

NETDEV WATCHDOG: eth0: transmit timed out
eth0: Tx hung

The system pauses for 3-5 seconds during this error and then continues happily.

dmesg info:

Jan 20 17:14:40 dewey kernel: eth0: Broadcom BCM5700 found at mem feb00000, IRQ 17, node addr 00065b3a09fc
Jan 20 17:14:40 dewey kernel: eth0: Broadcom BCM5401 Copper transceiver found
Jan 20 17:14:40 dewey kernel: eth0: Scatter-gather ON, 64-bit DMA ON, Tx Checksum ON, Rx Checksum ON
Jan 20 17:14:40 dewey kernel: bcm5700: eth0 NIC Link is UP, 100 Mbps full duplex
Jan 20 17:14:39 dewey network: Bringing up interface eth0:  succeeded
Jan 21 09:04:36 dewey kernel: NETDEV WATCHDOG: eth0: transmit timed out
Jan 21 09:04:36 dewey kernel: eth0: Tx hung

Is this a hardware error? Should I upgrade to the 2.4.9.13 kernel? Any advice appreciated! Please cc [email protected] in reply.

Thanks you,

-joe

---------------------------
[email protected]
(603) 646-0387
---------------------------

#1 lore raw
Quoted 3 lines

I have 2.4.7-10smp (RedHat 7.2 install) running on a dell on a dell 2550, the systems runs a mysql/apache applicaton (blackboard). Several times a day, as the load increases I get the following error:

Update to the errata kernel. You should do this anyway as per the advisory. It might help with the broadcom problem - that I don't know about.