belkin f5u022 pcmcia usb card

---------- Forwarded Message ----------

Subject: belkin f5u022 pcmcia usb card
Date: Mon, 20 Jan 2003 18:33:21 -0500
From: Robert Bisping <[email protected]>
To: [email protected]

I am having problems getting this card to work on my thinkpad 760ED I keep getting No IRQ known for interrupt pin A of device 04:00.0 Please try using pci=biosirq

I have found out that the card does work under linux and it is supposed to use IRQ 11 but how do I get it to set pin A to IRQ 11?

also what exactly is it refering to pci=biosirq where would I use that? i have tried to use it in boot up but it does not seem to have any affect unless I am using it wrong. if it supposed to be in a config file I need to kow which one and where it should be put. if i need to RTFM i need to kow which one to look at cause none of them seem to be helping. Thanx for your assistance

Robert

added notes for kernel mailing list.
I am using 2.4.18 kernel I have recompiled multiple times trying to find what might be causing this and if i need to send my kernel parameters I can. In the pcmcia-cs on sourceforge I was told i would probably have to ask here as this is handled by the yenta driver in the kernel.

thanx

ok, since I recieved no response from first try here goes more info:
I am using a thinkpad 760ED and I have tried puting APCI code in my kernel but it appears my laptop does not support it. The problem appears to be in the PCMCIA-CardBus bridge not being able to assign an IRQ.

I am uncertain if this is in the yenta driver code or in the PCI systems code. so I do not know who to even ask for direct assistance in correcting the problem.
I have heard the yenta driver is linus' but I do not know if the problem is before it loads or during. any assistance would be appreciated.

Rober Bisping