blink driver power saving
A message that is not in the archive (sent off-list or not yet received): [email protected]
A message that is not in the archive (sent off-list or not yet received): [email protected]
A message that is not in the archive (sent off-list or not yet received): [email protected]
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 10 lines · Andi Kleen
Quoted 9 lines · Linus Torvalds
Quoted 4 lines · Andi Kleen
What is so bad with it? Note it's a debugging facility and used for kcrash kernels where the video output doesn't work. But they normally only run a few minutes to dump the previous state to disk and then reboot.
It has been a total disaster from beginning to end.
Quoted 8 lines
Quoted 1 line
It wastes power.
Again:
It's not intended for normal kernels. It's a debugging feature. It's not intended for normal kernels. It's a debugging feature. It's not intended for normal kernels. It's a debugging feature.Got it now? Power wasting or not just doesn't matter for it.
There may be some setups that would overheat due to the sudden load, while still running fine under normal conditions. Especially if the fan is off or broken.
Signature · 4 lines
Fun things to slip into your budget An abacus Friß, Spammer: [email protected] [email protected]