Skip to contentSkip to conversation

Applied "regulator: Introduce property to flag set-load support" to the regulator tree

PATCH Mark Brown 1 participant 1 message Sep 17, 2015

Subsystems (2)
lore
Share & tools
lore

Mark Brown

author maintainer
#0 lore raw

The patch

regulator: Introduce property to flag set-load support

has been applied to the regulator tree at

git://git.kernel.org/pub/scm/linux/kernel/git/broonie/regulator.git

All being well this means that it will be integrated into the linux-next tree (usually sometime in the next 24 hours) and sent to Linus during the next merge window (or sooner if it is a bug fix), however if problems are discovered then the patch may be dropped or reverted.

You may get further e-mails resulting from automated or manual testing and review of the tree, please engage with people reporting problems and send followup patches addressing any issues that are reported if needed.

If any updates are required or you are submitting further changes they should be sent as incremental updates against current git, existing patches will not be replaced.

Please add any relevant lists and maintainers to the CCs when replying to this mail.

Thanks,
Mark

Quoted 1 line

From b263d20373d7726dd3ac0cd5e32f123e69a02847 Mon Sep 17 00:00:00 2001

From: Bjorn Andersson <[email protected]>
Date: Tue, 18 Aug 2015 15:14:06 -0700
Subject: [PATCH] regulator: Introduce property to flag set-load support

Introduce "regulator-allow-set-load" property to make it possible to flag in the board configuration that a regulator is allowed to have the load requirements changed.

---
 Documentation/devicetree/bindings/regulator/regulator.txt | 1 +
 drivers/regulator/of_regulator.c                          | 3 +++
 2 files changed, 4 insertions(+)
Documentation/devicetree/bindings/regulator/regulator.txt +1 -0
index 24bd422..1d112fc 100644
@@ -11,6 +11,7 @@ Optional properties:
 - regulator-always-on: boolean, regulator should never be disabled
 - regulator-boot-on: bootloader/firmware enabled regulator
 - regulator-allow-bypass: allow the regulator to go into bypass mode
+- regulator-allow-set-load: allow the regulator performance level to be configured
 - <name>-supply: phandle to the parent supply/regulator node
 - regulator-ramp-delay: ramp delay for regulator(in uV/uS)
   For hardware which supports disabling ramp rate, it should be explicitly
drivers/regulator/of_regulator.c +3 -0
index 250700c..499e437 100644
@@ -76,6 +76,9 @@ static void of_get_regulation_constraints(struct device_node *np,
 	if (of_property_read_bool(np, "regulator-allow-bypass"))
 		constraints->valid_ops_mask |= REGULATOR_CHANGE_BYPASS;
 
+	if (of_property_read_bool(np, "regulator-allow-set-load"))
+		constraints->valid_ops_mask |= REGULATOR_CHANGE_DRMS;
+
 	ret = of_property_read_u32(np, "regulator-ramp-delay", &pval);
 	if (!ret) {
 		if (pval)
Signature · 1 line
2.5.0