Applied "regulator: DT: Add DT property for active-discharge configuration" to the regulator tree

The patch

regulator: DT: Add DT property for active-discharge configuration

has been applied to the regulator tree at

git://git.kernel.org/pub/scm/linux/kernel/git/broonie/regulator.git

All being well this means that it will be integrated into the linux-next tree (usually sometime in the next 24 hours) and sent to Linus during the next merge window (or sooner if it is a bug fix), however if problems are discovered then the patch may be dropped or reverted.

You may get further e-mails resulting from automated or manual testing and review of the tree, please engage with people reporting problems and send followup patches addressing any issues that are reported if needed.

If any updates are required or you are submitting further changes they should be sent as incremental updates against current git, existing patches will not be replaced.

Please add any relevant lists and maintainers to the CCs when replying to this mail.

Thanks,
Mark

From: Laxman Dewangan <[email protected]>
Date: Wed, 2 Mar 2016 16:24:45 +0530
Subject: [PATCH] regulator: DT: Add DT property for active-discharge
configuration

Add common DT property for regulator node to support of active discharge enable/disable configuration of regulator.

---
 Documentation/devicetree/bindings/regulator/regulator.txt | 5 +++++
 1 file changed, 5 insertions(+)

index 1d112fc456aa..ecfc593cac15 100644
@@ -44,6 +44,11 @@ Optional properties:
   any consumer request.
 - regulator-pull-down: Enable pull down resistor when the regulator is disabled.
 - regulator-over-current-protection: Enable over current protection.
+- regulator-active-discharge: tristate, enable/disable active discharge of
+  regulators. The values are:
+	0: Disable active discharge.
+	1: Enable active discharge.
+	Absence of this property will leave configuration to default.
 
 Deprecated properties:
 - regulator-compatible: If a regulator chip contains multiple

2.7.0