net: marvell: mvpp2: clear flow control modes in 10G mode
Subsystems (3)
PATCH 1/1 net: marvell: mvpp2: clear flow control modes in 10G mode
When mvpp2 configures the flow control modes in mvpp2_xlg_config() for 10G mode, it only ever set the flow control enable bits. There is no mechanism to clear these bits, which means that userspace is unable to use standard APIs to disable flow control (the only way is to poke the register directly.)
Fix the missing bit clearance to allow flow control to be disabled. This means that, by default, as there is no negotiation in 10G modes with mvpp2, flow control is now disabled rather than being rx-only.
--- drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c | 5 +++++ 1 file changed, 5 insertions(+)
drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c +5 -0
@@ -4532,8 +4532,13 @@ static void mvpp2_xlg_config(struct mvpp2_port *port, unsigned int mode,if (state->pause &MLO_PAUSE_TX ) ctrl0 |=MVPP22_XLG_CTRL0_TX_FLOW_CTRL_EN ; +else + ctrl0 &= ~MVPP22_XLG_CTRL0_TX_FLOW_CTRL_EN ; +if (state->pause &MLO_PAUSE_RX ) ctrl0 |=MVPP22_XLG_CTRL0_RX_FLOW_CTRL_EN ; +else + ctrl0 &= ~MVPP22_XLG_CTRL0_RX_FLOW_CTRL_EN ; ctrl4 &= ~MVPP22_XLG_CTRL4_MACMODSELECT_GMAC ; ctrl4 |= MVPP22_XLG_CTRL4_FWD_FC | MVPP22_XLG_CTRL4_FWD_PFC |
Signature · 1 line
2.7.4
From: Russell King <[email protected]>
Date: Sat, 09 Feb 2019 16:06:51 +0000
Quoted 11 lines
When mvpp2 configures the flow control modes in
mvpp2_xlg_config()for 10G mode, it only ever set the flow control enable bits. There is no mechanism to clear these bits, which means that userspace is unable to use standard APIs to disable flow control (the only way is to poke the register directly.)Fix the missing bit clearance to allow flow control to be disabled. This means that, by default, as there is no negotiation in 10G modes with mvpp2, flow control is now disabled rather than being rx-only.
Signed-off-by Russell King <[email protected]>
Applied.